Alright guys I finally started tearing the T/A down. I have the intake off and the Fast almost assemblied. I would like to remove the coolant lines running under the intake but don't know if they make a kit to plug off the water ports on the block! Any info is helpful on this.

Now for the Headers I have the old ones off and the passanger side in place but have run into the f**king driver side common problem. I took a hammer to the firewall but the place that I need to really hit is too close to the engine block. The last header port is hitting that small square block on the engine. I have also tried loosing the motor mount and jacking it up no help their. The last thing that I have to try loosing the rear transmission mount and lift there hopefully that will get it done. This is a bit*h to do by your self.

AHHHHHHHHHHHHHHHHHHHHHHHHHHHH! Venting