Results 1 to 7 of 7
Thread: Window/door problems
-
04-09-2007, 09:24 PM #1
- Join Date
- Mar 2007
- Location
- Harmony NC
- Age
- 48
- Posts
- 22
Pewter- 2000 Z28
Window/door problems
I have noticed that if I roll the drivers window all the way down it seems to push the door panel out some. Then when I roll it back up it "pop" before it starts rolling up. Any idea what might be broken or out of alignment?
-
04-10-2007, 07:23 AM #2
- Join Date
- Mar 2007
- Location
- manassas, VA
- Posts
- 7
Silver- 99 z28 camaro
i would pull off the door panel and take a look thats the only way youll find out for sure
-
04-10-2007, 11:50 AM #3
- Join Date
- Mar 2007
- Location
- Omar's Tittie Taverna & Grill, Deh Rawod
- Posts
- 1,446
18D Cock Diesel- 1999 Z28; 98 SS #2043 RIP
one of the window regulator bolts may be loose and when your window is down the motor is moving and thus pushes in towards the door panel causing it to move. But this is all conjecture until you remove the door panel and have a look.
-
04-10-2007, 02:15 PM #4
- Join Date
- Feb 2007
- Location
- San Jose, CA
- Posts
- 27
Red- 2002 Camaro SS
-
04-10-2007, 07:41 PM #5
mine does the EXACT same thing, i have noticed today that if i roll mine almost all the way down, the window can move forward and back about an inch and a half, guess i just gotta take off my door panel and check.
-
04-11-2007, 10:38 AM #6
- Join Date
- Mar 2007
- Location
- Omar's Tittie Taverna & Grill, Deh Rawod
- Posts
- 1,446
18D Cock Diesel- 1999 Z28; 98 SS #2043 RIP
be careful when removing the door panel. Those clips can be quite fragile.
-
04-19-2007, 11:28 PM #7
- Join Date
- Aug 2006
- Location
- Canyon Country,California
- Age
- 48
- Posts
- 40
Silver- 1995 Chevy Camaro LT1
Yea,Mine did that same shit.I took the door panel off and it came off track and one of the bolts to the regulator came loose and fell off.So I put the bolt back in and put the window back in the crease in the window seal to line it back up and the window worked fine after that.Make sure when U re align the window use the motor to line up the bolts while holding the window straight
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Help: Power window hitting door?
By CD99Firebird in forum General HelpReplies: 20Last Post: 07-09-2015, 02:44 PM -
Door window guide
By JWSmythe in forum General HelpReplies: 0Last Post: 05-24-2008, 02:35 PM -
door Window outside weatherstriping
By slikws6 in forum General HelpReplies: 1Last Post: 05-10-2008, 09:47 AM -
need driver door/w window
By LS1buckey in forum Appearance SectionReplies: 2Last Post: 03-18-2008, 04:56 PM -
Loose door window....Help!!!
By jeremy_m70 in forum General HelpReplies: 4Last Post: 08-05-2007, 01:47 PM
Bookmarks