Results 1 to 8 of 8
  1. 08-27-2006, 02:18 PM #1
    mvvette97
    mvvette97 is offline
    Member mvvette97's Avatar
    Join Date
    Aug 2005
    Location
    leon iowa
    Age
    50
    Posts
    174

    black
    1997 corvette 00 WS6 TA

    problem with K&N filter fitting loose

    Anybody had this problem? I had a K&N in my WS6 and the filter was not tight in the air box. I could reach in through the holes and push up on it. I thought maybe the foam strip was gone that sticks on the underside of the lid but it is there. It is part#33-2118 so it should be the correct one. HELP!
    Reply With Quote Reply With Quote
  2. 08-27-2006, 02:30 PM #2
    Tman
    Tman is offline
    Member Tman's Avatar
    Join Date
    Aug 2005
    Location
    Woodstock, GA
    Posts
    469

    Black
    2000 WS6

    I run a Holley.. But a friend of mine has a K&N ...his came with a
    gasket. Did yours have a gasket in the box for a seal??
    Reply With Quote Reply With Quote
  3. 08-27-2006, 03:00 PM #3
    mvvette97
    mvvette97 is offline
    Member mvvette97's Avatar
    Join Date
    Aug 2005
    Location
    leon iowa
    Age
    50
    Posts
    174

    black
    1997 corvette 00 WS6 TA

    Quote Originally Posted by Tman View Post
    I run a Holley.. But a friend of mine has a K&N ...his came with a
    gasket. Did yours have a gasket in the box for a seal??
    Yea it did. It shows that you put it on the lid but it is still loose. Where did you get the Holley?
    Reply With Quote Reply With Quote
  4. 08-28-2006, 07:51 AM #4
    sunsetorangess
    sunsetorangess is offline
    Life in the Fast lane sunsetorangess's Avatar
    Join Date
    Aug 2005
    Location
    Bragg NC
    Posts
    2,834

    Met. Sunset Orange
    01 SS

    Send a message via AIM to sunsetorangess Send a message via Yahoo to sunsetorangess
    I had the same issue and then some so i went back too paper.
    problem solved
    J
    2001 SS, Its not the car its the Driver that matters....
    Reply With Quote Reply With Quote
  5. 08-28-2006, 09:48 PM #5
    rbob93
    rbob93 is offline
    Single Malt rbob93's Avatar
    Join Date
    Aug 2005
    Location
    Ft. Lauderdale, FL
    Age
    76
    Posts
    2,706

    Sebring Silver
    2000 CamaroSS



    That's the very reason I shitcanned that POS K & N and run a paper!

    $50 filter that lets dirt into my engine, yeah right!
    Reply With Quote Reply With Quote
  6. 08-29-2006, 02:53 AM #6
    Tman
    Tman is offline
    Member Tman's Avatar
    Join Date
    Aug 2005
    Location
    Woodstock, GA
    Posts
    469

    Black
    2000 WS6

    Quote Originally Posted by mvvette97 View Post
    Yea it did. It shows that you put it on the lid but it is still loose. Where did you get the Holley?
    Check out a few of the sponsors on the board. Many sell it.
    Reply With Quote Reply With Quote
  7. 08-29-2006, 04:26 AM #7
    va2001ss
    va2001ss is offline
    Member va2001ss's Avatar
    Join Date
    Aug 2005
    Location
    Northern Virginia
    Posts
    103
    2001 Black SS #5228

    The K&N that the LS1 takes was originally sized for a Jeep(cross reference it) that's why it is not an exact fit like paper or others.
    Reply With Quote Reply With Quote
  8. 08-30-2006, 03:47 PM #8
    INMY01TA
    INMY01TA is offline
    Senior Member INMY01TA's Avatar
    Join Date
    Jan 2006
    Location
    Marylandistan
    Posts
    5,761

    Black
    2001 Trans Am (sold)

    Paper ftw
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. oil filter fitting on new oil pan
    By nath in forum LSx Retrofit and Swap
    Replies: 5
    Last Post: 01-02-2012, 04:45 PM
  2. Oil fitting-new!
    By Jarlaxle in forum General Help
    Replies: 2
    Last Post: 11-21-2009, 11:46 AM
  3. problem getting caliper loose to change pads
    By Speedy_Gonzales in forum General Help
    Replies: 11
    Last Post: 08-11-2007, 07:08 PM
  4. lid airbox filter problem (added ws6 lower box)
    By CDS98Z28 in forum General Help
    Replies: 12
    Last Post: 10-02-2006, 09:02 AM
  5. K&N air filter, loose piece of wire found WARNING
    By SV8 in forum External Engine
    Replies: 1
    Last Post: 03-03-2006, 04:48 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules