Gauges

[scott5]

Anyone ever use the autometer digital gauges? I was thinking of getting a fuel pressure gauge to make my digital wideband and was curious if anyone had any issues with it? Also what kind of gagues match the best with the stock? I hate stuff mis matching.

[pajeff02]

I run the Autometer digital fuel pressure and transmission temperature gauges. Both work great and I have no hesitation recommending them. I'll see if I can find the pics.

[pajeff02]

Fuel pressure sender mounted to rail:




Fuel pressure gauge in the lower pod and POS Innovate LC-1 in the top:




Trans temp mounted low against the console -- worked out great mounting it there:

[scott5]

I just bought the lc-1 off my buddy. What dont you like about it?

Hmm i wondering if i will be able to use that cause my nitrous distribution block will be mounted there for the fuel.

[pajeff02]

My LC-1 throws an error code whenever I open my cutout or go WOT. I even installed a spacer on the sensor per Innovate's recommendations. You should be able to plumb a "T" into your attachment to run the sender.

[scott5]

My LC-1 throws an error code whenever I open my cutout or go WOT. I even installed a spacer on the sensor per Innovate's recommendations. You should be able to plumb a "T" into your attachment to run the sender.

Hmm.. Well I will try it, worst case it does mess up I will just buy a different one. I only paid 100 for the lc1 and gauge

[pajeff02]

Make sure you perform both the heater and free air calibrations when you install it.

[0verkill]

I have there digital shift light tac and the lights are going out on the tac part with just a few hundred miles on it

[flybird]

Pretty sweet!