Results 21 to 24 of 24
-
01-21-2008, 11:38 AM #21
nos
just buy the vehicle specific kit from nos. i built a kit and used parts i wanted and it cost more. at least get good solenoids. my friend had a cheap solenoid for a purge and it got stuck wide open cost him top sportsman points champ.also use good nos filter.mine clogged, all gas ,no juice ,booom!
-
01-21-2008, 02:08 PM #22
solenoids need to be checked on a reguler basis...especially if your not running a filter. debris can get into and clog the noid. fuel noids have little rubber seals that swell up if you use a certain type of fuel which need to be replaced occasionally or what you said can happen. i had a problem with an older TNT kit i had where this happened and TNT is not a cheap kit by any means.
FYI....their are only 2 major solenoid manufacturers so there is no such thing as a cheap solenoid but there is such a thing as Neglect...just thought you should know this.
-
01-21-2008, 07:03 PM #23
nos
there was no neglect, just a cheap nos budget (noid). only high dollar purge from now on. 7.04 @198.78 yeahh boyyy!
-
01-21-2008, 07:15 PM #24
nos
u can have a wot switch, but u still need a activation switch. i'm on the line at wot without a box. get a progressive controller for a NOS kit. we call it a nite-ress-kit we're not fast n furious we're slow n curious .
Last edited by racer426; 01-21-2008 at 07:21 PM.
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
What would I need to forge to run low boost safely
By BrownsMillsAntz in forum Forced InductionReplies: 7Last Post: 02-16-2012, 05:32 AM -
Question: How do I safely remove my PCM
By SVG210 in forum Internal EngineReplies: 3Last Post: 05-06-2008, 08:39 PM -
how much hp can a stock bottom end take safely?
By blackls1ta in forum Internal EngineReplies: 14Last Post: 07-11-2007, 07:10 AM -
How much power can stock LS1 block safely handle?
By svtben in forum Forced InductionReplies: 1Last Post: 03-29-2007, 03:00 PM -
What's a good way to put someone under safely?
By 98-LS1 in forum Almost Anything GoesReplies: 13Last Post: 03-09-2007, 04:54 PM



Reply With Quote


Bookmarks