Mullet project

[67CamaroRSSS]

1984 Camaro t-top 350 4 bolt/ built 700r4/12 bolt project

350 4-bolt main block
12:1 forged pistons
pink rods
steel crank
HD flexplate
.500 lift Crane Cam
109 Lobe Center
Solid Lifters
1:6 roller rockers
Ported heads, larger valves
Threaded studs
Pushrod guideplates
Dual 450 CFM Holleys
Weiand Tunnel Ram
MSD distributor, ignition, coil, cap and rotor
1987 Corvette 700R4
Superior shift kit
10 vane pump
Kevlar bands
10 clutch 3-4 clutch pack
28 element sprag clutch
2000 stall convertor installed
3500 stall included with car
4:10 mechanical posi
12 bolt rear with disc brake setup

3500 OBO

This car was just posted for sale with the local F body club. The drive train alone might be worth this amount (or less).

What do you think: Pass or at least take a look?????

[86 IROC-Z]

Third gen = Fail

/thread

[67CamaroRSSS]

My idea is to use the tranny in my 67 (it seriously needs OD), and the engine (or parts of it anyway - 12:1 comp, dual quads and solid lifters are a bit radical) and rear end in my 89.

I dunno, but it sounds tempting......

[86 IROC-Z]

To be honest with you, if I had a daily driver and enough extra money, I would probably get it if it were in good condition.

Any pics or numbers? (hp, tq, 1/4, etc)

[67CamaroRSSS]

It was just posted today. I have the sellers ph #. I haven't gotten home to call yet.

[redls1]

Heres a pic of my 92 camaro I sold last year. It was my first engine build. Did a 385ci stroker. Learned alot.

http://wm52.inbox.com/thumbs/3_d5478...3_tn.jpg.thumb

[MagicMan]

STock heads? I don't think that car is worth it.

[Nitro_Junkie97]

i dont think its that bad of a deal

[astyles]

dooooooooooooooooooooo it.......