Results 1 to 5 of 5
-
07-08-2009, 08:31 PM #1
Clutch won't disengage - Throwout Bearing Install
I just replaced the throw out bearing and after vacuum bleeding it with a mighty vac the clutch still wont disengage. Could I have done something wrong during the install or do I need to keep bleeding? I did not bleed the throw our bearing because I was told it was pre-bleed. I used the link below for mighty vac bleeding instructions.
http://www.performanceworks1.com/ls1...h_bleeding.htm
-
07-12-2009, 08:28 PM #2
- Join Date
- Jun 2009
- Location
- tinley park il
- Posts
- 26
black- 99 trans am ws6 ram air
keep bleedin it took me 2 hours to bleed mine
-
07-13-2009, 12:26 PM #3
-
07-13-2009, 05:06 PM #4
I bleed it some more and that fixed it! Thanks!
-
07-13-2009, 05:16 PM #5
wont disengage i had the same problem but with mine it was because two springs on my clutch broke!!!
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
scratching noise---throwout bearing?
By jmatt07 in forum Manual TransmissionReplies: 1Last Post: 01-30-2009, 06:27 AM -
throwout bearing size?
By ldanny in forum Manual TransmissionReplies: 1Last Post: 06-17-2008, 02:00 PM -
fork and throwout bearing
By pelniz in forum DrivetrainReplies: 0Last Post: 07-08-2007, 01:36 PM -
Throwout Bearing
By Dancswbirds in forum Firebird / WS6Replies: 2Last Post: 07-27-2006, 11:35 AM
Bookmarks