looking for 600rwhp or more

[AFASTYZFR1]

Yep.....If you let it keep hitting, you will get a hole in your floor....
Here is how I fixed it........and it fits under the carpet fine

[Octavain]

Man if you could find that it would help! A LOT!!! Because I have to get a new driveshaft since the swap because it made my stock one about 1/4 inch to small for me to be comfortable when laying down the petal. I didn't see that it was already posted, lol. So did you fix it from above or from the underside of the car? Do you think I could fix it from underneath the car if I took the driveshaft out?

[AFASTYZFR1]

Man if you could find that it would help! A LOT!!! Because I have to get a new driveshaft since the swap because it made my stock one about 1/4 inch to small for me to be comfortable when laying down the petal. I didn't see that it was already posted, lol. So did you fix it from above or from the underside of the car? Do you think I could fix it from underneath the car if I took the driveshaft out?

I fixed it from above.......made template out of cardboard.....then made the pieces with metal and welded all together

[Frost]

The nice part about his picture is it shows you where to cut.

[stevenm357]

The nice part about his picture is it shows you where to cut.

exactly what I was thinking.

couple of questions on the rear you got. will the factory type ( I have BMR replacement) still work? what kind of spacer did you have to do on the sway bar?

Thanks
steve

[AFASTYZFR1]

exactly what I was thinking.

couple of questions on the rear you got. will the factory type ( I have BMR replacement) still work? what kind of spacer did you have to do on the sway bar?

Thanks
steve

I have a 25mm rear bar and it fits fine

[Octavain]

I replaced my stock rear end with a Moser 9". The factor rear sway bar (19mm) didn't fit around the axle housing. So I had to get a spacing get from http://www.hawksthirdgenparts.com/ca...lationkit.aspx which gave me ample amount of clearence.