is this a decent deal

[jefff82]

Is ot better to get one in the I pipe or 2 in the y. Electric would be nice but if 2 in the y shouldn't be too difficult to remove manually

[0rion]

I would just do 1 in the i-pipe and do electric. You can still get to the cutout in the I to do it manually if you put it under the rear passenger seat but having the switch in the car is 99% of the fun. The electric part of it really isn't that expensive and super simple to install. The cutout is ~$40 I think then you pay a shop $20-$30 to weld it in for you so you're only out $70....the electric valve is $170ish so you're out $250 or less for the whole thing.

[pajeff02]

Agree. A single cutout positioned in the area under the rear seat is your best option. There is an existing rubber grommet in that area that you can route the wiring through and then go under the carpet to the center console. You can pull power for the cutout from the fuse panel on the driver side of the dash. Just make sure that you install a fuse close to the power tap.

[jefff82]

Agree. A single cutout positioned in the area under the rear seat is your best option. There is an existing rubber grommet in that area that you can route the wiring through and then go under the carpet to the center console. You can pull power for the cutout from the fuse panel on the driver side of the dash. Just make sure that you install a fuse close to the power tap.

local exhaust shop said he didn't sell cutouts buy would install for 50. to try jegs or summit to get one. figured the wiring would be easy. ill definitely look into it since sometimes everyone like it loud.

[jefff82]

so if stock pipe is 2.5 inch is that what size cutout I get or do I get a 3 inch

[pajeff02]

You'll have to match the kit to the diamter of your mid-pipe, otherwise you'll be cobbling things together. With my brother's mad TIG welding skills, we grafted a custom cutout onto my Magnaflow catback mid-pipe:

[jefff82]

I ordered a 3 inch from summit. Was that too big

[jefff82]

You'll have to match the kit to the diamter of your mid-pipe, otherwise you'll be cobbling things together. With my brother's mad TIG welding skills, we grafted a custom cutout onto my Magnaflow catback mid-pipe:

that cutout is clean. can u add electric cutout to a manual one

[raynor139]

You'll have to match the kit to the diamter of your mid-pipe, otherwise you'll be cobbling things together. With my brother's mad TIG welding skills, we grafted a custom cutout onto my Magnaflow catback mid-pipe:

that cutout is clean. can u add electric cutout to a manual one

The electric part just bolts onto the cut out. The one in the pic is a cut out then the electric opener switch and then a turn down.

[jefff82]

can u buy the electric valve by itself. I ordered a summit racing manual. can I add a the electric valve to it.And is 3 inch too big for stock I pipe

[pajeff02]

You can buy just the electric cutout and switch. I do not recall the diameter of the stock mid-pipe.

[Firebirdjones]

I believe the diameter of a stock I-pipe is an oddball size of 2.75" And by oddball I mean everything in the aftermarket you buy for exhaust systems is going to be 2"- 2 1/4" - 2 1/2" - 3" - 3 1/2" etc...