Engine bay junk

[third_shift|studios]

What can i do to clean up/move all that wiring mess around the manifold? i think it looks horrible and clutters up the engine bay

[basballny2]

tie it up and put some cheesy looming on it haha

[stephen02ws6]

fuel rail covers will hide the wires

[slp1122]

a couple options:

you can relocate the throttle box behind the pcm, so the cable comes from the back,
and
you can get different fuel rails so the connection is in the back.

[third_shift|studios]

a couple options:

you can relocate the throttle box behind the pcm, so the cable comes from the back,
and
you can get different fuel rails so the connection is in the back.

more about this please? link or write up, pix?

[squee]

more about this please? link or write up, pix?

Just search for it on Tech. Theres a couple threads about it.

[slp1122]

more about this please? link or write up, pix?

i haven't done this yet, but apparently all you need to do is unbolt it from the wheel well, take out your pcm, put the whole unit behind the pcm (there is room) and then put the pcm back.

[squee]

i haven't done this yet, but apparently all you need to do is unbolt it from the wheel well, take out your pcm, put the whole unit behind the pcm (there is room) and then put the pcm back.

Yup. Most people just use zip ties.

[BDowning]

more about this please? link or write up, pix?

Go to the Appearance Sec and look for My underhood Dressup, post #66, this is what you are looking for!!

Bill

[third_shift|studios]

I spoke with Lucky13, he hath shown me the way Looking forward to making that alteration in the near future