Results 1 to 2 of 2
Thread: Getting a new rear!
-
03-15-2013, 04:13 PM #1
Getting a new rear!
Just talked to my trans guy about rear end options and he is going to order a pre fabled 9'' housing and all the other goodies for a total cost of $1700+labor. Not bad in my opinion
-
09-16-2020, 12:15 PM #2
- Join Date
- Sep 2020
- Location
- Wasilla, Alaska
- Posts
- 1
Black- 2000 Camaro SS
New member here and I'm a little late to this party but just ordered a fabricated 9" 4:30's with a spool. Now concerned how much the T-56 can handle before I spit it out. 2000 Camaro SS, 408 stroker, nitrous. Made 513/502 whp on the motor, 603/602 on a small spray at Texas Speed who built the motor. I've read the OEM T-56 can handle about 450 tq.
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Rear LS1 98-02 Rear Disc Backing Plates/Calipers/Brackets
By peetsjunkie in forum Parts Wanted / TradeReplies: 2Last Post: 10-02-2007, 08:53 AM -
Rear alignment is off after Koni/!= rear isolator lowering, car pulls to right, specs
By anestech* in forum Suspension and HandlingReplies: 13Last Post: 07-08-2007, 09:42 AM -
Rear alignment issues after removing rear spring isolaters, adj trac bar fix it?
By anestech* in forum Suspension and HandlingReplies: 1Last Post: 06-19-2007, 07:06 PM -
Randy's Rear End Shop Get's Punked (Prank) - Woman looking for a bigger rear!
By powermelissa in forum Multimedia SectionReplies: 0Last Post: 05-25-2007, 10:37 AM -
how to remove the rear inside panels, where the rear spkrs are ?
By Eugenio_SS in forum ConvertibleReplies: 4Last Post: 05-19-2006, 04:39 PM
Bookmarks