Printable View
hey trying to get some direction are were to go next. 01 ss full bolt ons 4000 circle d stall 10 bolt rear 4.10 gears and a custom grind cam 614 lift im thinking. Just left the tune shop lowered my shift speeds by 17% and lowered my shift points and still bangs the limiter. maybe i need to contact frost.
Are you leaving it in drive or over drive ? Mine won't shift by it self any other way.
I'm leaving it in overdrive
They need to lower the mph and rpm shift points for each gear. Take it back and try again... What are they tuning with ? HP Tuners ?
My 1 - 2 shift is set at 29 mph and 6200 rpm to achieve a 7000 rpm shift. My limiter is at 7400...
my begining shift was at 6000 and shift at 6800 limiter set at 7000 now he bumped it back at i think5600 with a shift point of 6300
hp tuners
Set at 5600 with a shift poing of 6300. This is just me but it sounds like the tranny is starting to go. I would double check with Frost. When your shift points were set higher I would not have said that. I would have backed down or gone back to stock shift points to see.Quote:
Originally Posted by sloroller
Are you on stock Rod Bolts?Quote:
Originally Posted by bills98ta
H-Beam Rods / ARP's and lunati +12cc dome pistons / 5.3 heads done up yielding 14:1 CR. 4600 stall / 4.10 gears. 150 shot too / ect.. .The tuner might want to do some comparison's on other transmission tunes to tweak it in...Quote:
Originally Posted by Z28Thunder
I ran my stock bottom end with the same set up, until it pulled a rod bolt.Quote:
Originally Posted by Z28Thunder
He has to lower the mph shift points too. They can be zeroed but I didn't.Quote:
Originally Posted by sloroller
Dont know much about the internals other than having comp springs ls6 block and full slp exhaust fast 92 intake fast big mouth 92 tb slp lts slp cme and full suspension work with qa1son all corners, ut pretty much stock also has 243 heads no work done to them.
stock rod bolts
Any ideas about breaking the tens on motor with my set up na motor?
I had my stock bottom motor hitting 10.8's with a 150 dry shot. Walbro 255 fuel pump & 30lb injectors at the time. And a little more tuning ! LOL
Went back to my tuner and dialed it in a little and fixed it, went to the the track and had no problems. thanks for the input
Get any good times ?
ran 11.4 on the car @118 n/a cam and olt ons stock heads 7.2 through the eighth
Not bad at all !!! 4000 stall, I'm guessing a 1.4X - 60' ???Quote:
Originally Posted by sloroller
dead on 1.43 60ft