Printable View
Hey i just bought a tripple guage pod and im wondering what you guys suggest i should put in there. I only plan on doing the following mods....
Slp lid
New T/B and intake
Mild cam
Lts, ory, cat back
gears
shift kit and stall
small shot of nitrious
tune
What do you guys think? THANX
Travis
Looks like we're in the same boat...i donno wut to get or how to go about hook them up to an ls1
If it me I would put in a fuel pressure and no2 pressure for sure.
lol..im in the same boat as well..would like some suggestions
I did the fuel pressure / NOS / wide-band !
Thats what im going to do. thanx!!Quote:
Originally Posted by bills98ta
Fuel pressure, N2o pressure, and tranny temp.
how do you hook up the fuel pressure gauge?
The fuel rail has a pressure tap that you remove the cap & valve stem, then hook the sending unit to it. Be careful not to over tighten & twist the fuel rail ! If you have a NOS presure switch, you need a T fitting to hook up both ! Good Luck !Quote:
Originally Posted by BirdFlewLS1
hey thanks for the quick reply man...thanks again
That's the easy part ! Getting the wires run into the car is the challenge !!!
yeah i knew that when i ordered them....its a never ending battle. but its needed and worth the hassle. also to hide the wires is fun to...i like stock appearing besides the lingenfelter intake and lid.lol
how far does the fuel pressure gauge need to go? 0 to 15 or 0-100 psi
does anyone have any suggestions to where there is already a pre drilled hole in the firewall of the car that ill be able to run the wires through when I decide to put mine on?
I drilled a hole beside the steering column from the inside, above the carpet. Accessible below the brake booster...
well, at idle your fuel pressure should be 58psi so you'll need the 0-100psi. Also, if you drill your own hole in the firewall make sure you put a grommet in it so the wires don't end up chaffed. You can get grommets at just about any parts store and they're cheap.
there is a gromet in the firewall on the passenger side near where the computer sits in your engine bay.Quote:
Originally Posted by blackhawk01
awesome..thankyou :)
does fuel pressure go down as you drive? or rev? all i can find in my gauges are 0-60psi in the in the white faced gauge
It might drop under heavy loads, but should hold around 58lb or so... You might get away using the 0-60 guage... If it would drop a lot, you might want to upgrade the fuel pump !!!