Manual headlight motor adjuster
Been working on my Formula all day in the rain trying to restore the correct headlights and fog light that a previous owner totally hacked up. He removed the low beam buckets and spliced 4 cheap Walmart driving lights in their place. 2 lights on each side. One was about 2 1/2 inches and shaded blue and the other was about 3 1/2 inches with crappy blue bulbs. Looked like a nightmare and the light quality was pathetic. Then he removed the factory fogs and rigged up smaller driving lights just like the ones he put for headlights. Nothing was done with any skill...zip ties, cut wires and electrical tape everywhere...nightmare...just finding the headlight buckets was almost impossible and the factory fogs were pretty expensive. Anyhow to shorten the story I have everything all wired and all the lights work correctly but now the headlight motors don't. One gear has been going bad for a few days and I have a brass gear ordered but the other headlight will not go up or down. I manually screwed it in the up position and now it is stuck there. I tried to manually screw the driver's side up but I guess the gear is so far gone it will only go up about 80%. I hear a short click but no grind from the passenger side. When I turn off the headlights they stay in the up position and neither of them grind like they do when the gear strips out. Not sure if when I untangled his rat's nest of wires i somehow disconnected something like a ground...Suggestions where to start? I wonder if he hacked up a ground wire or something. I guess tomorrow if the rain stops I'll hit it after work. What a PITA.
