Printable View
Hey guys I installed the fast 92/92 combo on the car yesterday. Everything seemed fine but now the trans is acting up like crazy when I stand on it the car will stay in gear or upshift????? If i manaully downshift it works great and hauls anyone heard of this bullshit before?
The only thing that comes to mind is that GM service bulletin about overly-oiled K&N air filters where the oil transfers onto the MAF sensor wires and throws off the grams per second reading. Thats been known to cause transmission shift concerns. Anything like that ring a bell?
It would if I used a k&n filter but i dont... I didn't have my egr block off plate at the time so i just disconnected the sensors and the tubes just bend out of the way. I have to put the block off plate on tonight or tomorrow you think that may have anything to do with it? I know all this computer bs one things not hooked up the whole thing could be jazzed up :(
yeah if you have an open EGR port on the exhaust manifold/header then thats a major exhaust leak that could be throwing off the O2 sensor readings and might be causing some other problems
Yeah I'm putting on the egr block off plate on asap. The odd thing about it is when i manually downshift it, It flys big difference from before i'm just upset because my corsa install was fucked up as well and $2400 later my exhaust is chatting and the tranny is acting up.
are you running with the egr open??? did you get tuned after all the installs???
well i think we figured out what the problem was. :D egr needs to removed or closed.
Yeah the intake mani is closed/ sealed however the egr tube is just disconnected sensors removed etc. i didn't have the egr blockoff plate with me at the time so i'm going to put that on asap. I wouldn't see how that would effect the trans? I havn't had it tuned yet i have a april 9th appointment though. I gotta put on the electroic water pump still.Quote:
Originally Posted by shady milkman
yeah... you got a poop load of fresh 02 coming in your header then... that is throwing off your 02 and causing all kinds of mayhem...Quote:
Originally Posted by Itllrun
I had the o2's deleted in my computer as well as torque management but i can see how the computer would be all over the map.
you didn't get ALL of the o2's deleted you only got the rear ones removed.
Quote:
Originally Posted by Itllrun
more than likely you got the rear 02's done... unless you went wideband... you'd be amazed on what the pcm does... :yup:
I only got the rears done. Yep that must be the problem thanks so much guys :woot:
I'm such a noob lol
If I remember right one of the wires that is in the EGR harness goes back to the O2 sensors. I would make sure that the EGR harness is unplugged and none of the wires is touching the motor. I taped mine up and stuck them out of the way.
Alright cool man thanks i'll look into that as well. I'd like to see the car go 12.50's this season i just hope i can work these kinks out so i can go get it dyno tuned :yup:Quote:
Originally Posted by PFM