Printable View
I just replaced the throw out bearing and after vacuum bleeding it with a mighty vac the clutch still wont disengage. Could I have done something wrong during the install or do I need to keep bleeding? I did not bleed the throw our bearing because I was told it was pre-bleed. I used the link below for mighty vac bleeding instructions.
http://www.performanceworks1.com/ls1...h_bleeding.htm
keep bleedin it took me 2 hours to bleed mine
+1 same here, I was getting seriously pissed off, because I was thinking the master was bad and didn't want to have to pull it out to get another one...Quote:
Originally Posted by chuckunit69
I bleed it some more and that fixed it! Thanks!
wont disengage i had the same problem but with mine it was because two springs on my clutch broke!!!