Tuning issues

[Mrmumbels]

I’m running into an issue where my LQ9 is asking for lots of fuel at cruising speeds. Running a terminator x max and can’t seem to figure this out. I did find a vacuum leak by blowing smoke into one of the lines with intake blocked. It was a hole I had plastic welded and not done a very good job. after properly repairing it today I tested with a couple rubber gloves over the k take, my air compressor in one line, and a bottle of soapy water. It tested fine and I was excited to go for a spin, but it’s still asking for full fuel at 2k rpm’s. I call it the blob. Anyone have any ideas what could cause this? I’ve posted a pic of my ve table and how much more fuel it wants in learning. Any ideas on what to try would be highly appreciated.
https://ibb.co/FmLQpLV

[Mrmumbels]

This ended up being a bad map sensor