Here is the story. I was driving to work this past week in the rain. It was raining pretty hard. Running down the freeway about 65 in 6th gear. Car was running great and all of a sudden felt like it started to misfire. If i revved up the engine with the clutch in it would clear up but right after letting off the clutch and put a load on the engine it would start to stumble again. I got the car home that evening and found that the engine control fuse was blown. Replaced the fuse and turn the car on and instantly blew the fuse again. I found some wires that were exposed on the O2 sensors. Replaced both O2s and the fuse no longer blew. Tried driving the car and now it stumbles a little on acceleration at about 2500 rpm and clears up. If i go to WOT it stumbles bad and wont clear up. I have tested the MAF and cleaned it is reading properly. I have changed out the MAP sensor. Checked for Vacuum leaks. None to be found. Replaced the spark plugs. I have been driving the car and am now getting rich codes on bank 1 and 2 amd still stumbles bad at WOT. I am stuck and have no idea where to go from here. Anyone have the same issue or any insight on where i should go from here.
Car has ported and polished LS1 heads. Camed. 1.7 rockers. Long tube headers. And has been tuned with the current mods before i bought the car.