Results 1 to 3 of 3
Thread: flycut pistons with afr /heads ?
-
10-08-2010, 04:26 PM #1
- Join Date
- Oct 2010
- Location
- Greensboro, NC
- Posts
- 33
99white/ 78 blk&gold- 1999 30thTrans Am&78 T/A
flycut pistons with afr /heads ?
Hey guys I had someone tell me recently tbhat when I put my heads on I was susposed to flycut the pistons. I have AFR 205 heads and am running Comp Cams 588/581 camshaft. I have had it together for 3 years now with no problems. I recently found out I have a head gasket leaking into a cyl not mixing with oil. The engine did run up to red mark for tem/p once and I have been noticing some lifter noise lately. I am planning to pull it back daown and replace the head gaskets. I will check piston clearance again to make sure. Was just wwondering if anyone had run into this issue?
99 30th ann Trans Am WS6, AFR heads, hooker long tubes, comp cams581/592, chrome moly push rods, ARP head studs, all free WS6 mods, hurst shifter, lous short stick, several other mods and tuning 396RWHP, 385RWTQ.....changing intake and injectors next....
-
10-08-2010, 06:47 PM #2
what are the specs on the cam, and what cc are the heads? you will want to check the clearence, but if you don't have to flycut the pistons, don't do it because all you will be doing is dropping your compession ratio
-
10-08-2010, 07:10 PM #3
- Join Date
- Oct 2010
- Location
- Greensboro, NC
- Posts
- 33
99white/ 78 blk&gold- 1999 30thTrans Am&78 T/A
Can specs. 581 intake and .592 ex. Duration Is 224 /230 @112 intake center line lobe separation 114.0 part# on the heads is 1510. 205 mongoose heads. I just read my installation instructions again and it said
Part#'s 1610 thru 1680 require relief. So I am good on that. I remember checking it and everything cleared
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Question: Do I need to flycut my pistons?
By jcob in forum Internal EngineReplies: 2Last Post: 11-25-2010, 06:41 AM -
shortblock heads intake suspension parts pistons
By nitrobusa in forum Parts For Sale / TradeReplies: 13Last Post: 12-17-2009, 06:03 PM -
Question: Heads, Cam & Pistons
By 1fastkingcab in forum Internal EngineReplies: 7Last Post: 05-24-2009, 05:33 AM -
How to flycut pistons
By krusemj in forum Internal EngineReplies: 2Last Post: 07-12-2007, 03:30 PM -
ls1 block,heads,pistons,rings,rods,brand new
By mad3125 in forum Parts For Sale / TradeReplies: 2Last Post: 10-19-2005, 03:07 AM
Bookmarks