Results 1 to 4 of 4
Thread: Turning a crank?
-
07-03-2007, 06:14 PM #1
- Join Date
- Apr 2006
- Location
- Northern Kentucky
- Age
- 47
- Posts
- 96
Pewter- 2000 Camaro SS
Turning a crank?
How deep can one take off an Eagle stroker crank and it still be considered good?
-
07-05-2007, 08:43 AM #2
most grinders won't go past .030". and that will be fine.
Cold Air Intake, Muffler Delete, Vinci High Performance Dual Valve Springs, Hardened Pushrods, Yella Terra 1.85 Rockers, Some Hydropdipped Stuff, Strut Tower Brace, Some SS Badges, boost/vacuum gauge, fuel pressure gauge, some checkered stripes, drilled/slotted rotors, ZL1addons Stealth wickerbill, Ruxifey LED side markers
-
07-05-2007, 08:47 AM #3
- Join Date
- Apr 2006
- Location
- Northern Kentucky
- Age
- 47
- Posts
- 96
Pewter- 2000 Camaro SS
Yeah I just called Eagle. They said no more than .020 or it'll be under the nitride coating.
-
07-05-2007, 01:12 PM #4
Yea I was going to say if you went .030 you'd probably be going a little too far.........
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Why Is My Crank Not Turning - Pit Stop - Tech Q&A
By Ed Blown Vert in forum Almost Anything GoesReplies: 0Last Post: 07-20-2010, 04:00 PM -
turning .avi into a .jpg
By NE98LS1 in forum Almost Anything GoesReplies: 0Last Post: 05-07-2010, 02:42 PM -
Turning off T/C on a '95 z28
By manarth5103 in forum Camaro / SSReplies: 2Last Post: 04-10-2010, 05:14 PM -
Turning 21 what to do?
By 98T/Aformula. in forum Almost Anything GoesReplies: 24Last Post: 03-18-2009, 02:57 PM -
turning 30
By chuck4345 in forum Almost Anything GoesReplies: 40Last Post: 10-03-2008, 05:58 AM
Bookmarks