Results 1 to 2 of 2
Thread: Mech Nitrous Guage
-
06-16-2007, 02:19 AM #1
Mech Nitrous Guage
Again... I have the LS1 NOS kit going on a 00 SS... I have the dual purge kit going to the Nitrous Sol. (in) port, and I have a remote bottle opener going on the bottle. The directions from Autometer w/ the Mech. gauge tell you to either run the line for the guage to the Nitrous Sol. (in) port, OR the bottle itself. Is it possible to have more than one "Acc." at either of those locations? If not, Im going to by the electrical gauge, but I dont know where the sender is suppose to go! This is the last part of my install before I start pushin buttons! Thanks a bunch guys.
-
06-16-2007, 12:08 PM #2
yes, it is possible. all you need is is a -4AN male to -4AN female adapter with a 1/8 NPT hole in it. just like the one that is used for the purge solenoid.
Cold Air Intake, Muffler Delete, Vinci High Performance Dual Valve Springs, Hardened Pushrods, Yella Terra 1.85 Rockers, Some Hydropdipped Stuff, Strut Tower Brace, Some SS Badges, boost/vacuum gauge, fuel pressure gauge, some checkered stripes, drilled/slotted rotors, ZL1addons Stealth wickerbill, Ruxifey LED side markers
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
console mounted nitrous pressure guage
By maxwax in forum NitrousReplies: 1Last Post: 07-26-2009, 07:04 PM -
WTB: nitrous accesories-heater, guage, purge, etc.
By hallass in forum Parts Wanted / TradeReplies: 5Last Post: 08-20-2007, 12:03 PM -
Rearend Cover, A/F guage, Custom FRC's, Nitrous Switch Panel
By ICRAZY6 in forum Parts For Sale / TradeReplies: 15Last Post: 08-15-2007, 12:51 PM -
Triple guage pillar and cobalt guage for sale
By mikewood21 in forum Parts For Sale / TradeReplies: 11Last Post: 06-20-2006, 03:47 PM
Bookmarks