Purge mounting Question

[Toes]

Well I got my purge solenoid and I want to get it as close to the nitrous soleniod as possible if I use the connector supplied and mount it directly to the nitrous soleniod will I have a problem using only the braket supporting the nitrous solenoid leaving the purge soleniod suspended with only the pipe fitting? the kit I have in is a HSW wet plate and am currently using the supplied mounts

[Eagle]

I don't know if that's a problem. Ask Matt over @ HSW how to handle it. I'm sure it's not an issue to let the pipe fitting support it.

-Eagle

[Toes]

Ya I guess I should have started there but I think it will work too

[MikeSomething]

Toes, I don't know what the mount looks like, but I would just use your best judgement. Mount it to the other solenoid and see how it feels, put pressure on the purge end and see if it's real flimsy. This isn't rocketscience.

[Danger731]

That is what I did, the bracket is fine. I have the same kit with the plate.