Results 1 to 6 of 6
Thread: little things
-
08-20-2007, 06:59 PM #1
little things
I just got my kooks headers and am looking for a good gasket and bolts so that once they are on i dont haveto mess with them again. any suggestions?
-
08-20-2007, 07:00 PM #2
-
08-20-2007, 08:43 PM #305 PBM GTOCold Air Inductions CAI,Relocated IAT with omega,Slp Predator tune,Flowmaster axle back with H pipe,Custom tuned TCM.BC Racing coil overs
Sold 01 z28
-
08-21-2007, 04:28 AM #4
-
08-21-2007, 05:06 AM #5
Fel-Pro
I used Fel-Pro and a new set of GM bolts. Apply "torque strip" to the bolt heads after tightening so you can check to see if they are backing out from time to time.
2000 Z28 M6, SLP Lid, SLP Bellows, SLP UD,
P&P Maf, TB By-Pass, PS Shorties, LS6 Intake, FAST 78mm TB, Hooker CB, Hurst Billet, Front Tower Brace, small 218/218....527/527....114 cam.
337rwhp/348rwtq
-
08-21-2007, 08:51 AM #6
a buddy aslo recomended fel pro, but those or gm i think would be good. Also would i need the "locking" header bolts i seen advertised.
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Wanted: Need a lot of things!
By izzhemp in forum Parts Wanted / TradeReplies: 0Last Post: 12-21-2009, 09:37 PM -
its the little things
By damianj03 in forum Almost Anything GoesReplies: 57Last Post: 11-28-2009, 02:27 PM -
Wtb A Few Things
By Qwk94Z28 in forum Parts Wanted / TradeReplies: 1Last Post: 07-22-2007, 10:18 AM -
Few things I need to get rid of
By 5.0THIS in forum Rocky Mountain MembersReplies: 3Last Post: 05-09-2007, 01:29 PM -
things we need to do
By hotrodd in forum Political / Debate ForumReplies: 39Last Post: 08-26-2006, 07:13 PM
Bookmarks