Results 41 to 44 of 44
Thread: Clutch job
-
07-18-2012, 04:27 AM #41
- Join Date
- Jun 2012
- Location
- florida
- Posts
- 545
seal
I didnt realize it was that huge and difficult of a job to change the rear main seal. You guys havnt lived until you have changed one in a flathead ford, the seal is a 2 piece rope the size of your thumb. What kind of alingment tools are required. I think ford or someone used a silmilar rear main like ours but they used the face of the seal for contact on a surface so alignment was not an issue.
-
07-18-2012, 06:16 PM #42
- Join Date
- Jun 2012
- Location
- florida
- Posts
- 545
manual
I was looking at the 1998 factory repair manual online and it doesnt show any special procedure for the rear main. Section 6-432
-
07-18-2012, 10:01 PM #43
-
07-19-2012, 05:24 PM #44
I would have to dig out my manuals -- going from memory, the tool indexes over the back of the crank and has fingers that center the rear cover.
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
New Disc Clutch System News - What's New In Clutch
By Ed Blown Vert in forum Almost Anything GoesReplies: 0Last Post: 04-27-2010, 05:44 AM -
Had Clutch slave cyl, clutch master cyl, and Clutch kit installed now I got problems
By 7camaro7 in forum Manual TransmissionReplies: 21Last Post: 12-13-2007, 07:41 PM -
Tranny, Clutch, or Clutch Hydraulic System?
By IZNUTHN in forum Manual TransmissionReplies: 2Last Post: 07-31-2007, 06:13 PM -
clutch locks up 1st gear in traffic while riding clutch
By Trixter in forum Manual TransmissionReplies: 9Last Post: 04-22-2007, 09:01 AM -
z06 clutch for sale, pressure plate clutch disk and flywheel
By themack56 in forum Parts For Sale / TradeReplies: 2Last Post: 07-06-2006, 07:15 PM
Bookmarks