Results 1 to 2 of 2
Thread: maf question
-
04-03-2007, 03:21 PM #1
maf question
i bought a 6.0 maf from a 03 silverado, thats a 5 wire connector right? and my 98 is a 3 wire because the iat isn't incorperated into the maf right? so i would have to get one of these?
http://paceperformance.com/index.asp...D&ProdID=24660
i was reading this article
http://www.ls1howto.com/index.php?article=25
not sure if i can use these tables or if the stock truck tables will be fine
just wanna be 100% sure about everything
-
04-03-2007, 03:29 PM #2
looks like it should work. i would use the truck table valves as a start.
Cold Air Intake, Muffler Delete, Vinci High Performance Dual Valve Springs, Hardened Pushrods, Yella Terra 1.85 Rockers, Some Hydropdipped Stuff, Strut Tower Brace, Some SS Badges, boost/vacuum gauge, fuel pressure gauge, some checkered stripes, drilled/slotted rotors, ZL1addons Stealth wickerbill, Ruxifey LED side markers
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
speedometer question + top speed question
By Krazy351w in forum General HelpReplies: 7Last Post: 06-21-2007, 05:51 PM -
HPIII question (not the same old question)
By slims00ls1z28 in forum Computer & TuningReplies: 5Last Post: 06-01-2007, 04:55 PM -
97 Bird Headlight question also engine noise question
By Zapper2003 in forum General HelpReplies: 2Last Post: 12-13-2006, 03:03 AM -
Speedometer question, RPO question
By acrylicophobia in forum Firebird / WS6Replies: 12Last Post: 11-02-2006, 07:08 AM -
Sex Question spinoff- PORN QUESTION
By egaian in forum Almost Anything GoesReplies: 77Last Post: 07-26-2006, 03:07 PM
Bookmarks