Results 1 to 1 of 1
Thread: 65 Comet Cyclone restoration
-
04-05-2016, 06:37 PM #1
65 Comet Cyclone restoration
This car started out as a rust free Arizona car, but was a race car and run hard most of it's life so it needed a lot of metal surgery. Mainly floors and firewall from blown clutches and driveshafts. The shock towers were beaten in, braces cut, and large holes cut with a torch at the rear inner fender wells, all for different engine swaps this car has seen over the years. Along with many holes drilled through out the engine compartment for different fuel systems and ignition systems.
Now going back together as a day 2 hot rod and put back on the street. I had already stripped it at the start of the video and built the new 9 inch rear underneath so the car would roll.
https://www.youtube.com/watch?featur...&v=Nnglwmxx-L4
Coming soon the engine and trans build, wire the car, interior etc..
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Pontiac Trans Am Restoration - Restoration Instead Of Replac
By Ed Blown Vert in forum Firebird / WS6Replies: 0Last Post: 10-21-2011, 05:20 PM -
1 owner daily driver 1964 mercury comet
By 1MileCrash in forum Almost Anything GoesReplies: 26Last Post: 07-16-2010, 10:58 PM -
Restoration Shops - Corvette Restoration Made Easi
By Ed Blown Vert in forum CorvetteReplies: 0Last Post: 05-18-2010, 02:50 AM -
Restoration Shops - Corvette Restoration Made Easi
By Ed Blown Vert in forum CorvetteReplies: 0Last Post: 05-03-2010, 04:40 PM -
Vomit Comet
By CJREX in forum Almost Anything GoesReplies: 2Last Post: 01-07-2010, 05:41 AM
Bookmarks