Results 1 to 8 of 8
-
08-01-2012, 07:52 PM #1
- Join Date
- Jan 2007
- Location
- colorado
- Posts
- 4
midnight blue- 1998 Trans Am
Boiling sound at radiator, radiator cap blowin off
My car is blowing the radiator reservoir cap off. It seems to have a lot of pressure... Was thinking head or head gasket but it still runs great, no radiator fluid in oil, changed cap no difference.. Thermostat is good pulled it out yesterday, the car also likes to get nice and warm as this is happening, only happening when I get in it. Drive like a Sally and she doesn't overheat.. I know this is a pressurized system, but I pulled both radiator hoses off and ran the car with straight water going into the water pump, did the same with the car off and it had the same flow rate, could this be the water pump? Please help!!
-
08-01-2012, 08:12 PM #2
- Join Date
- Feb 2010
- Location
- north bay california
- Age
- 35
- Posts
- 2,973
Black- 00 camaro ss M6 #6695
could be thermostate, fans not working, or you need to replace the cap..
mine had the same issue a while ago, the problem was clogged hose, the one that goes to the reservoir, replaced that house, problem was gone
-
08-01-2012, 10:14 PM #3
- Join Date
- Jan 2007
- Location
- colorado
- Posts
- 4
midnight blue- 1998 Trans Am
Did your car overheat as well? And was it blowing radiator fluid out of the radiator reservoir cap as well?
-
08-01-2012, 10:35 PM #4
- Join Date
- Feb 2010
- Location
- north bay california
- Age
- 35
- Posts
- 2,973
Black- 00 camaro ss M6 #6695
yes the temp was always high, the antifreeze was coming out of the radiator cap, not the reservoir,
if its coming out of the reservoir, i would say is the termostate, you can also flush the cooling system.
-
08-01-2012, 11:14 PM #5
First check for leaks if your able to get a radiator pressure tester that does the radiator and has a cap tester do that this will put the system under pressure and see if youve got any leaks...If you dont have leaks - make sure your radiator is not plugged and is flowing properly- sometimes even a new thermostadt can be faulty-make sure its the correct temp range for your car and make sure you have it installed in the proper direction of flow-water pump impellars can go bad but unlikely- Now to the head gasket,your gasket can have a slight irregulariy-or the head itself can have micro-fissures (small cracks) so small that while not seeping anti-feeze into the oil CAN cause exhaust vapors to seep into the cooling system,this will cause high temperatures and boil-overs but the car will still run fine until it overheats...so when your just cruisin its ok but once under higher pressure the cooling system cant operate correctly and dissepate the heat generated by the exhaust gases.
-
08-02-2012, 07:41 AM #6
- Join Date
- Jun 2011
- Location
- Branchville, NJ
- Posts
- 3,111
Silver & Blue- 02 Camaro SS, 04 GTO
Do not over look collapsed hoses when you put pressure on them under WOT. You may also have a bad radiator, it may be cloged inside. Do you have an infrered temp gun, if so shoot the radiator and look for cold spots. If the hoses are more then 4 o 5 years old the replace them. Did you put the thermostat in hot water to see if it opened ? Waterpump impeller could also be the issue. Pull the pump ( better then blowing the engine )if the other ideas do not work. Good luck.
My ride is a 2002 Camaro SS SLP #3296 with 30k, LTH, 3" Y, CME, Frost tune, K&N, ported TB, Blackwing lid, Bellows, MSD, Denso Iridium, and 85mm MAF, Bilsteins, Eibach springs, SLP strut brace, Adj. Panhard, TA Girdle, UMI, Pro 5.0, Nitto NT555
My wife has a 2004 GTO with the rare SAP, 18" wheels, K&N Cold Air System, MSD, Ported TB, Frost tune, Denso Iridium, Flowmaster cat-back, 3200 Yank, 75k
-
08-05-2012, 05:59 AM #7
- Join Date
- Jan 2007
- Location
- colorado
- Posts
- 4
midnight blue- 1998 Trans Am
She's fixed
After reading and trying different thing for weeks I finally gave in, took it to a good little shop that does nothing but "Hot Rods" and within hours it was done. What was it?? Turns out it still needed to be burped. I tried doing that several times. Must be a trick to it that I never read. Thanks everyone for responding nonetheless.
-
08-05-2012, 04:29 PM #8
OooPs!
I forgot my mechanics 101`s first rule...try the simplest thing first!!!! My bad..I should know better too! While not a certified mechanic(dont have the patience,more of a driver then mechanic) ive had a few years (20 yrs)of automotive experience running a service station (family business)..and over the years ive seen it all!....But i have to admit i screwed the pooch on that one...
..The ol burping.....yeah alot of air bubbles can be trapped in the block or radiator...even the smallest air pocket can cause a problem!! Im glad you solved your problem but it also brought me back to basics...Instead of going all crazy thinking cracked blocks,bad impellars,collapsed hoses,clogged radiators (which were all good guesses!!) I forgot the golden rule.."'Start with the simplest thing FIRST!"
Last edited by SuperSSguy; 08-05-2012 at 04:32 PM.
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Help: Boiling sound at radiator cap
By Blue2KTA in forum General HelpReplies: 10Last Post: 07-31-2012, 06:02 AM -
Griffin radiator install, stand up radiator install
By 02Sweet in forum External EngineReplies: 12Last Post: 06-03-2012, 05:00 PM -
Project Shark Attack C3 Corvette Radiator Install - Radiator Fallout
By Ed Blown Vert in forum CorvetteReplies: 0Last Post: 04-03-2007, 09:20 AM -
LS1 radiator
By sammy burks in forum Parts For Sale / TradeReplies: 0Last Post: 09-11-2006, 06:19 AM -
LS1 radiator fan
By a10beav in forum General HelpReplies: 0Last Post: 07-26-2006, 07:36 PM
Bookmarks