No Start

[Obsession]

My car is acing funny and I hope I can get an idea from you guys. It sounds like I have the same issue as MrKid, the only differance is my pump is working and primeing but it acts like I am getting no fuel

Today I started my car just fine I drove it down town to best buy and the thing wouldn't start. It turns over just fine but it acts like it isn't getting gas. I checked the fuel pump and it works fine but I don't know if I have fuel pressure and don't know how to check it. I don't have a check engine light or any other lights on. I plugged in the code meter and I see that injector #1 and #2 is open I was there for 2 hours and got it started and noticed that the injectors said closed when it was running ... is this normal? I got home and let it set for 15 minutes and it started right up but then I let it set for a 1/2 hour and it wouldn't start again I did check the fuse for the injectors and it was ok but they were hot. What do you think? I did get it started again and it ran fine then I shut it off and I havent been able to start it for almost 2 days now

[Obsession]

When I was reading some of your replys somethine was said about the seat I don't know what that has to do with anything but I do move my seat back and forth when I get itn and out of the car so I put less ware on the seat but at the time the car was not starting I was not moving it and it started after 2 hours of setting in Best Buy parking lot now this tast time the seat was moved because my son wanted to drive it to his grandpas funeral and it hasn't started sence

[cammed goat]

Almost sounds like those two injectors are flooding the cylinders. But that's just me.

[Obsession]

Good news 4 me and maybe you may look into the same thing MrKid
I was going 2 take my car in but they wanted $300 just 2 look @ it I decided 2 look into it farther I took the starter relay and switched it with the ignition relay then my car would not turn over at all so I replaced both relays and the car starts fine. So MrKid may have a problem with the fuel pump relay

[Obsession]

Just a little more info I found online for Trans Am priming pressure should be 45 psi (not critical) bur cranking pressure should be 57 to 68 psi (critical) or the car won't start