Results 1 to 9 of 9
Thread: New Fuel Pump
-
09-21-2010, 08:27 PM #1
- Join Date
- Sep 2010
- Location
- pensacola
- Posts
- 16
- 98 trans am
New Fuel Pump
ok i need a New Fuel Pump bad mine wines SO BAD the more i drive the louder it gets and if i drive to much my car loser power. like it will chug sorry its kinda hard to explain.
but im almost sure i need a new one i tryed changing my fuel filter no luck.
but which one should i get?
i have a 98 trans am
thanks
-
09-21-2010, 08:34 PM #2
get a racetronix kit with the wiring harness. will do you some good later if you mod it much.
Thanks,
Mark
KYSpeed.com | FREE SHIPPING & HANDLING | PRICE MATCH | EMAIL
Kook's | American Racing Headers | Vararam | HallTech | Textralia | SPEC | McLeod | Raptor | Trick Flow | AFR | ECS
| FAST | APS | TTi | Procharger | RPM Transmission | Comp | DMH | HP Tuners | PFADT | SLP | STS
-
09-21-2010, 08:49 PM #3
- Join Date
- Sep 2010
- Location
- pensacola
- Posts
- 16
- 98 trans am
thanks alot man
-
09-21-2010, 08:51 PM #4
no problem
let me know if you are needing one I have one in stock.
Thanks,
Mark
-
09-21-2010, 09:02 PM #5
- Join Date
- Sep 2010
- Location
- pensacola
- Posts
- 16
- 98 trans am
cool can i get the info on it like how much and such?
-
09-21-2010, 09:05 PM #6
turn on your pms so I can send over info.
or call me at 606-422-8502 tomorrow and I will tell you all about it.
thanks,
Mark
-
09-21-2010, 09:19 PM #7
- Join Date
- Sep 2010
- Location
- pensacola
- Posts
- 16
- 98 trans am
ummm how do i turn pms on? sorry
-
09-21-2010, 09:26 PM #8
I think you new ten post to get them turned on?
I sent you a message on this board also.
thanks,
Mark
-
09-22-2010, 06:46 PM #9
I just wanted to share my experience with my racetronix setup. Make sure that you get the wiring harness and check all the connections. I had a faulty ground in the factory harness. No biggy I just ran a new piece of wire with a connector. Second look closely at the flex tube when that comes out of the pump. Mine had a pin hole and was causing the pressure to drop. It will take a few seconds for the car to start once the pressure was up. I was able to fix this with a solder pencil. I just melted down the plastic and sealed the hole. I was promised a new flex tube and oetiker clamps from racetronix like in a week. It's been like 6 months now and i still haven't received them so i'm sure there are not sending them.
After 2 months my pump started whinning like the old one. It happens after driving 40 mins or so. It don't matter if the tank is full or low. That was the reason I change it on the 1st place. I contacted racetronix and they told me that is normal for the pump to make noise once it warms up...
I just wanted to make sure you are aware that the noise might come back. I haven't had any issues with it except the whinning noise. Very easy to install once you get the pump out. I tried to drop the tank of my 98 but the tank is metal and the fill tube is also metal. I even dropped the whole rear end down and still not enough clearance around the filler neck to get the tank out. I tried this for 6 hrs with breaks. I made the hard desicion of cutting the trap door and I had that pump out in 15mins. I'm not happy with it but I will hate to have to replace the pump in like a year or less and have to go thru all that again. I do agree with other people. If you can drop the tank do it that way. Is not fun to cut a car up
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Fuel pump fuel guage issues on my '02 B4C
By ANDYZ28 in forum Camaro / SSReplies: 7Last Post: 12-29-2014, 10:30 AM -
Pontiac Fuel Pumps - Do You Have The Right Fuel Pump?
By Ed Blown Vert in forum Firebird / WS6Replies: 0Last Post: 03-15-2011, 09:20 PM -
LS1 all yr fuel injectors, oe fuel rail, pump,more
By Frost in forum Parts For Sale / TradeReplies: 7Last Post: 04-27-2009, 02:26 PM -
Stock fuel pump/ how much fuel pressure can I run...
By jmangler in forum LT1Replies: 3Last Post: 10-02-2006, 06:23 PM -
Fuel Pump Pump Problem?????? Help!
By undertakersT/A in forum General HelpReplies: 4Last Post: 04-24-2006, 09:55 AM
Bookmarks