Results 21 to 27 of 27
Thread: Clutch problems. Slave cylinder?
-
04-15-2010, 12:51 PM #21
Thanks, I don't have small hands but my helper does so we'll see how it goes.
-
04-15-2010, 01:24 PM #22
And from looking at it they probably installed the clutch MC before the brake booster at the factory.
-
04-15-2010, 01:40 PM #23
- Join Date
- Mar 2007
- Location
- Gainesville, VA
- Posts
- 654
I think it's going to be a PIA. It's a tight fit took me way longer to replace that MC then it should have. I replaced everything on my maxima MC, slave and all the lines in about 1/4 the time it took on the camaro. At least when you are done your hydraulic issues should be over. Make sure you flush the line very good after doing the drill mod to get all of the metal shavings out.
-
04-15-2010, 01:46 PM #24
Thanks. Well, at least I won't be pulling the tranny this time.
-
04-16-2010, 09:39 AM #25
I got the MC out ok but I need a helper to bleed it. It'll have to wait until tomorrow.
I can see how it's going to be nearly impossible to reinstall and some suggest drilling the holes in the fire wall bigger for an easier fit. How much bigger? Anyone remember what sized bit? I don't want to oversize the holes.
-
04-16-2010, 11:47 AM #26
Ok all done. I took it out and romped on it. It works great. I couldn't have done it without Turbojimmy's help. Thanks Jim!
-
04-16-2010, 12:01 PM #27
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
What is the correct slave cylinder to use with LS7 clutch
By 99RedTa6spd in forum General HelpReplies: 2Last Post: 10-06-2013, 07:25 AM -
Question: Clutch and slave cylinder replace
By YellowJacket in forum GTOReplies: 3Last Post: 07-08-2012, 03:11 PM -
Had Clutch slave cyl, clutch master cyl, and Clutch kit installed now I got problems
By 7camaro7 in forum Manual TransmissionReplies: 21Last Post: 12-13-2007, 07:41 PM -
Upgrade clutch master and slave cylinder?
By Black02LS1 in forum Western MembersReplies: 4Last Post: 04-16-2007, 07:31 AM -
Needing clutch master cylinder, line and slave...anyone help?
By Dat240zg in forum GTOReplies: 0Last Post: 01-05-2007, 01:33 PM
Bookmarks