Results 1 to 8 of 8
Thread: Interchangeability
-
11-09-2009, 11:36 AM #1
- Join Date
- Nov 2009
- Location
- New England
- Posts
- 41
Blue- Dodge Magnum
Interchangeability
This is a simple question I suspect has a hair-pullingly complicated answer: from 1998-2002, what year trans can and can't work with what year engine?
Also, did GTO's use the same trans as F-cars?
-
11-09-2009, 03:17 PM #2
They are all 4l60e's from 98 to 02 and as far as I know GTO's used the same exact trans.
Any 98 to 02 will work on an LS motor. The LT1 4l60e's used different bell I think. Might also be something different in the input shafts length, but I don't know for sure.
-
11-09-2009, 03:33 PM #3
-
11-12-2009, 01:13 PM #4
- Join Date
- Nov 2009
- Location
- New England
- Posts
- 41
Blue- Dodge Magnum
-
11-12-2009, 05:17 PM #5
any 98 to 02 f-body ls 4l60e should work. I don't recall any changes to the trans wire harness that would cause any problems.
-
11-13-2009, 04:36 PM #6
All 98-02 f-body A4 transmissions are the same. The truck transmissions have a different tail housing and linkage, they can be used on a f-body if you swap the linkage rod and the tail. The GTO has the same linkage and tail as the trucks but if the trans came out of a 6.0 they are 4L65E, which are stronger than the 4L60E. The 4L65E is interchangeable as long as you have the right linkage and tail housing.
-
11-17-2009, 06:28 PM #7
2000 4L60E in a 96 Z28
What would I need, to install a 2000 4L60E into a 96 LT1 Z28?? I can see the bell housing is different, but if I remove the alignment pin from the '00 trans, the bolt and alignment pin holes line up. I've heard that I need a spacer and different flywheel to make it work. I've read on here that I must change out the input shaft.
Any help appreciated.
-
11-19-2009, 07:15 PM #8
Hum I know I have seen the answer to this but can't remember. If you change the bell and the input you would be making it lt1 ready so you shouldn't need a fly. I just can't remember if you even have to change the input shaft. I know you do on the T-56 for lt1's to ls1's.
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Question: GTO Oil Pan interchangeability
By Roothawg in forum External EngineReplies: 0Last Post: 06-17-2011, 07:13 PM -
Question: Interchangeability
By cammed goat in forum GTOReplies: 8Last Post: 11-07-2010, 06:02 PM -
Question: Interchangeability (take two)
By Jarlaxle in forum Manual TransmissionReplies: 4Last Post: 11-12-2009, 06:21 PM -
Intake interchangeability
By speedkills in forum External EngineReplies: 7Last Post: 11-28-2006, 12:56 PM -
Gear set interchangeability(sp)??????
By pewter99ta in forum DrivetrainReplies: 1Last Post: 12-18-2005, 12:56 PM
Bookmarks