Results 1 to 6 of 6
  1. #1
    Junior Member
    Join Date
    Nov 2008
    Location
    Northern Utah
    Age
    41
    Posts
    58

    Metallic Blue
    94 Z28 A4 T Tops 52K MINT

    Intake Manifold gasket R/R 94 Z28 LT1?

    I need to replace my leaking intake manifold gasket asap. Anyone ever does this? How many labor hrs does it call for? Any tips or tricks?
    Thanks.

    Scott

  2. #2
    Junior Member 94TAGT's Avatar
    Join Date
    Apr 2007
    Location
    Fredericksburg,Virginia
    Posts
    20

    Sunfire Yellow
    1994 Trans Am GT

    Just changed mine out last week. Kind of a pain in the azz getting to a few of the bolts i.e. the ones on the back and one near the EGR which will most likely have to be removed. Took abut 4 hours to get taken off and replaced. Not too bad though. Dealership wanted to charge standard GM rate. 801.00 to do the job.

  3. #3
    Junior Member
    Join Date
    Nov 2008
    Location
    Northern Utah
    Age
    41
    Posts
    58

    Metallic Blue
    94 Z28 A4 T Tops 52K MINT

    Smile

    Thanks for the info man.

    Scott.

  4. #4
    Junior Member
    Join Date
    Nov 2008
    Location
    Northern Utah
    Age
    41
    Posts
    58

    Metallic Blue
    94 Z28 A4 T Tops 52K MINT

    Also i am not 100% sure it's the intake manifold that's leaking. I checked the oil sending unit sensor it was not leaking. What else could it be? I know it's coming from that area for sure. It leaks down on the trans bell housing then around where the cooler lines go into the trans and also by the trans dip stick tube, then on the ground. At first I thought it was the trans cooler lines or dip stick, but not it. It's engine oil for sure.
    My Z28 only has 52K original miles, so I knew it was going to start leaking once I drove it more.
    It's also leaking from the front crank seal, I think?
    Is the crank seal a common problem on these LT1's? I never had a problem with my ret. 94 but then again it had 140K original miles on it. Other than that my current 94 Z28 is not leaking any where else and does not burn any oil & runs like brand new!

    Any help with this issue would be great. Thanks, Scott...

  5. #5
    Senior Member bigrondownhiller's Avatar
    Join Date
    Feb 2006
    Location
    Orange County, NY
    Age
    49
    Posts
    2,693

    always dirty
    2013 Ram 2014 Caddy ATS

    Could be the valve covers or the rear of the intake. My front seal has leaked a little off and on. It is never a constant leak though. I would wash the rear of the engine down and try to see where it might be leaking from.

  6. #6
    Junior Member
    Join Date
    Nov 2008
    Location
    Northern Utah
    Age
    41
    Posts
    58

    Metallic Blue
    94 Z28 A4 T Tops 52K MINT

    Thumbs up

    Good tip I will give that a try. Thanks.

    Scott...







    Quote Originally Posted by bigrondownhiller View Post
    Could be the valve covers or the rear of the intake. My front seal has leaked a little off and on. It is never a constant leak though. I would wash the rear of the engine down and try to see where it might be leaking from.

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Question: Intake Gasket
    By Keith01 in forum General Help
    Replies: 6
    Last Post: 08-26-2011, 08:59 AM
  2. Help: GTO Intake Gasket
    By MichaelKnightrod in forum GTO
    Replies: 12
    Last Post: 01-06-2011, 10:26 AM
  3. Question: Intake gasket thickness
    By SteveCZ28 in forum General Help
    Replies: 10
    Last Post: 03-31-2010, 11:02 AM
  4. manifold gasket
    By itsfess in forum Internal Engine
    Replies: 3
    Last Post: 08-30-2008, 01:58 PM
  5. Leaking intake gasket
    By a338566 in forum GM Trucks
    Replies: 0
    Last Post: 03-04-2008, 03:26 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •