Results 1 to 2 of 2
Thread: Tuning issues
-
02-12-2023, 05:05 PM #1
- Join Date
- Feb 2023
- Location
- Tampa fl
- Posts
- 3
Tuning issues
I’m running into an issue where my LQ9 is asking for lots of fuel at cruising speeds. Running a terminator x max and can’t seem to figure this out. I did find a vacuum leak by blowing smoke into one of the lines with intake blocked. It was a hole I had plastic welded and not done a very good job. after properly repairing it today I tested with a couple rubber gloves over the k take, my air compressor in one line, and a bottle of soapy water. It tested fine and I was excited to go for a spin, but it’s still asking for full fuel at 2k rpm’s. I call it the blob. Anyone have any ideas what could cause this? I’ve posted a pic of my ve table and how much more fuel it wants in learning. Any ideas on what to try would be highly appreciated.
https://ibb.co/FmLQpLVLast edited by Mrmumbels; 02-12-2023 at 05:54 PM.
-
02-13-2023, 10:11 AM #2
- Join Date
- Feb 2023
- Location
- Tampa fl
- Posts
- 3
This ended up being a bad map sensor
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Tuning issues
By Naf in forum GM TrucksReplies: 7Last Post: 07-18-2007, 04:43 AM
Bookmarks