Results 1 to 4 of 4
Thread: ws6 u-joints
-
05-08-2018, 05:43 PM #1
- Join Date
- Jun 2012
- Location
- florida
- Posts
- 545
ws6 u-joints
I bought the recommended ac delco u-joints #89029292 but they look wimpy compared to the originals. They look a tad smaller too.
I am note going to hammer the car, just want to make sure they will fit ok.
-
05-09-2018, 08:23 AM #2
I had a situation with my driveshaft where the bearing on the driveshaft side was larger than the rear end side. Be sure to check the diameters when you install. But the Delco one's should be fine. The one that Strange sent me to install on a strange driveshaft to stock rearend was a Moog. I opted out of that one and just ordered a Spicer u-joint.
98 WS6 M6 ASC #2647
Forged Custom 408 w/Vortec YSi
-
05-09-2018, 11:24 AM #3
- Join Date
- Feb 2009
- Location
- Florida Man Status Acheivement
- Posts
- 11,785
Navy Blue Metallic- 98 T/A, 00 FBVert, 78T/A
I pretty much only use Moog U joints.
-
05-09-2018, 02:00 PM #4
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Ws6 u-joints
By johnfin in forum Firebird / WS6Replies: 4Last Post: 04-30-2018, 06:09 AM -
Is it my differential or u joints?
By Joel in forum General HelpReplies: 3Last Post: 06-11-2012, 06:59 AM -
U joints
By Supersport0126 in forum DrivetrainReplies: 18Last Post: 03-15-2012, 08:15 AM -
Help: u-joints bad??
By dennis ss in forum General HelpReplies: 3Last Post: 01-17-2011, 05:40 AM -
LS1 U Joints
By WS6ICK in forum General HelpReplies: 1Last Post: 07-25-2007, 02:18 PM
Bookmarks