Wire mod Gone south

[rsg98Z28]

so i did the wire mod a few weeks ago, looks nice but when i lowered the car and started it up my gas gauge wasnt working and mySES light came on, I tried to read the code with my hypertech programmer and it told me to remove the battery charger B/c the bat is putting out too many volts remove the battery charger then try again it wouldnt even read the code. P.S. when i did the mod i drilled a hole big enough fo the wires cut them and soldered them back together. I did it one connecto at a time so my thought is a or a couple of bad connections or swithched some wires.

[9t8z28]

so i did the wire mod a few weeks ago, looks nice but when i lowered the car and started it up my gas gauge wasnt working and mySES light came on, I tried to read the code with my hypertech programmer and it told me to remove the battery charger B/c the bat is putting out too many volts remove the battery charger then try again it wouldnt even read the code. P.S. when i did the mod i drilled a hole big enough fo the wires cut them and soldered them back together. I did it one connecto at a time so my thought is a or a couple of bad connections or swithched some wires.

Ouch! You cut the wires? I have not done the mod but I think you disconnect the harness from the ECM and feed it under the inner fender?

[rsg98Z28]

yup took a couple deep breaths and some serious balls and stupidity to cut the wire. I dont have school on monday though so hopefully i can get it fixed.

[lvbroham1]

Yea, that was a kinda questionable decision Lol, just like you said your best bet is to go through every wire again and make sure everything is connected right. Good Luck man.

[rsg98Z28]

yup ,thanks im definetley looking fowad to it