Results 1 to 20 of 43
Thread: First time at the track
-
04-11-2010, 05:04 PM #1
First time at the track
I went to the track this weekend for the first time running my car. i noticed a noise at just over 5500 rpm that sounded like little pieces of gravel bouncing off the bottom of my trans area. The car drives fine since, however i havent reved it that high since. The noise wasnt that loud but im not sure what it could be, any help or input? its an 01 m6 stock.
-
04-12-2010, 03:17 AM #2
I was thinking about that... Do you have the short throw shifter ? I remember that being loud ( tinny ) sounding in my 02 Z06 at higher rpm's.. I think it was vibrating on the stop bolt.
-
04-12-2010, 03:40 PM #3
it has the factory hurst shifter. if it was a valve issue would you hear it through the firewall or the tunnel? im heading back to the track this weekend, im gonna remove the preditor tune and see what happens.
-
04-12-2010, 03:43 PM #4
Try to have good fuel for the weekend too ! I hope to be there also.
-
04-12-2010, 03:45 PM #5
oh yeah did you run her after i left? How'd she do?
-
04-12-2010, 03:47 PM #6
i was running a fresh tank of Chevron 93 at the time
-
04-12-2010, 04:06 PM #7
I loaded mine up & took it home... MAF went south... Trying a SD tune now.
-
04-18-2010, 07:27 PM #8
went back to the factory tune and still have noise at high rpm. gonna do a trans flush and check for metal shavings. anything else i can check?
2001 Formula Firehawk #489 M6
Lid - Bellow - PP TB - BBK LT's - ORY - Magnaflow Catback - UMI Body Mounted Torque Arm - Spohn Adj. LCA's - Dale Jr Killer Wheels
-
04-18-2010, 07:48 PM #9
-
04-19-2010, 05:12 AM #10
[QUOTE=sometimes at WOT past 5500 rpms the shifter makes that sound like theres a loose bolt or something , half the time not always
[/QUOTE]
is it still there when your hand is on the stick? or is it just when its off? bills98ta mentioned something like that too. haven tried yet but gonna look into that. might be a day or two though cause i threw out my back ths morning, no banging gears like this!Last edited by WhiteHawk489; 04-19-2010 at 05:16 AM. Reason: cant spell for sh!t
-
04-19-2010, 04:24 PM #11
only happens half the time at WOT past 5500 rpms. nothings loose on the shifter , i installed it perfectly......
do you have headers ??
i read that the tube that connects from the headers to the plastic air hose has two gaskets in between them and when the gaskets crack or are damaged theres sometimes a loud ticking noise at WOT. .... i think thats whats going on with mine cause i did remove that pipe when i changed my plugs and wires in order to make room for the swap ......
i read it on an article on install university . heres an insert from the article:
Trouble Shooting: After this plug install if you hear a loud ticking sound when the engine is under load then you should check your gaskets between the AIR pipe and exhaust manifold.There is a metal gasket in between the AIR pipe and exhaust manifold. Be very careful not to damage this gasket. If it is broken or missing a piece you will get a loud ticking sound when the engine is under load. The part number for a replacement gasket is 12553617.
-
04-19-2010, 04:34 PM #12
no, no headers yet. i hope its just a shifter issue(vibration). the shifts feel nice and crisp, the clutch feels good, its got to be something stupid. i have a feeling when i drain the trans it will be clean(which im doing this week). when that happens im going back to the track and running balls out. dont get me wrong i dont want to break anything but if something does break at least ill know what was wrong. also i know a Firehawk can run better than a 14.01 @ 101, even with me driving!
-
04-19-2010, 04:37 PM #13
Last edited by FirehawkM6; 04-19-2010 at 04:43 PM.
-
04-19-2010, 04:38 PM #14
oh yeah?! Recommended fluid? Mobile 1 synthetic atf?
-
04-19-2010, 04:40 PM #15
yeah i was shifting at about 4900 - 5200. the noise scared me, its my dd!
what is the true redline?Last edited by WhiteHawk489; 04-19-2010 at 04:41 PM. Reason: redline Q
-
04-19-2010, 04:50 PM #16
yea this is my DD i put about 40 miles on her daily
im getting a gas saver next month
and drivin this baby on the weekends/ hot dates
but uh redline is about 6200 rpms... and once you get past that 5500 rpm mark you feel its true power. ..
definately get that noise checked out ...
-
04-19-2010, 04:57 PM #17
-
04-19-2010, 05:10 PM #18
-
04-19-2010, 09:42 PM #19
I have a A4 but had alot of noise above 5400 rpm it was the fuel pump dieing. At first I though it was coming from the trans but when we tried to tune it we niticed it ran lean up top and couldn't get the a/f ratio right till the new pump went in and good tune and no more niose. My MAF went south on me already.Replaced it with a graneelli and it's been ok.
1998 Trans Am 85k miles.
Bolt ons, MS3 113LSA cam, Circle D Stall, Tune, Modified WS6 style hood, Full Suspension, 6000k HID's, Clear Side Markers w/ Leds, Led 3rd Brake Light and 18" AR Staggered Killer Wheels w/ BFG KDW NT's.- Weekend Toy/DD
02 Trailblazer -Sold
09 Ram 1500 CC - Sold
09 Cobalt SS/TC - Sold
13 ram 1500 LoneStar CC 4x4 - Magnaflow, K&N,and more to come-DD/Toy
-
04-20-2010, 06:18 PM #20
is there any easy (cheap) way of testing to see if a fuel pump is going bad like checking amperage or something?
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
went to the track for the first time :)
By reaper ws6 in forum Drag RacingReplies: 22Last Post: 03-07-2012, 09:21 AM -
Question: First time at the track with the z28
By Jermocaleb in forum Drag RacingReplies: 9Last Post: 12-15-2011, 04:48 PM -
MVP Track Time 2010 Track Schedule
By Feffman in forum Road Racing / AutoXReplies: 0Last Post: 12-09-2009, 09:45 AM -
First time at the Track
By supercopone in forum Drag RacingReplies: 3Last Post: 11-21-2009, 09:40 PM -
Track Time
By ur jlus in forum Drag RacingReplies: 4Last Post: 02-05-2006, 06:58 PM
Bookmarks