Printable View
Has anyone had a problem where their selector switch for the A/C quit working? I switch it from defrost to floor to a/c and any other place, but it does not switch the air flow. I checked the hoses behind the selector and all are fine there. Is there a vacuum hose somewhere i could check?
Any ideas????
With a vacuum leak the default mode blows air only to the windshield/floor vents - if that's what is going on check all the vacuum lines behind the intake manifold.
ok, thats what it is doing. it only blows defrost and floor. I'll have to see if i can get back there to look.
Thanks
I have a 2000 t/a and it does the same thing. Did you get it fixed? if so what did you do?
I see this when people do intake swaps and forget to put the little vacuum line on the back or it falls off or something it'll cause this to happen.
The car is stock and i felt behind the intake manifold and there is nothing unpluged. I 'd like to think i would hear the hiss if it was unpluged dont you.
Most times you won't hear it over the engine/belt sound?
I checked today and all the vacuum lines are pluged in and there is nothing loose. I followed one line from the back of the intake to a tee of some sort by the computer under the hood passenger side which one goes into the firewall and one goes into a wire loom and to the front.The other line goes to a valve of some kind on the driver side. I checked behind the control pannel in the past and everything is in good shape. I will look into it more when it gets nice enough outside to drive it.
It is due to vacuum loss as others said. There is sometimes a one way check valve that goes bad also. I can't remember on the F body's.
If you take a hand vacuum pump and give the switch panel adequate vacuum I beat it will work fine.
I had this same problem last year. Drove me NUTS!! Turned out to be a L-shaped vacuum check valve under the hood, near the rear of the passenger side valve cover. It somehow had cracked. Replaced it (very inexpensive even at the "stealership" parts dept.), and it's been fine since. I bet that's your problem!
My tahoe had the same problem. I Found a diagram online of the cables that switch the vents and noticed one of them popped off.
Awesome, I'll look into replacing the valve next.I appreciate all of your opinions they are very helpfull.
I'm having problems with my head lights when i turn them off they are makin a buzzzing sound. and when i turn on my runnin lights my head lights pop up..any suggestions what might be wrong? is the head light moter goin out or is there a relay might of went bad???...
Do you hear the noise only while they opening and closeing or does it continue afterwards as well? Is the noise comming from inside or outside the car? When you say running lights are you talking about park lights?
My blower and rear defrost just stopped working all of a sudden.. fuses all look fine... grrrrr I can feel when I select the different positions.. and if its warm air or cold.. and I hear the "hiss" ing noise when I change the selections.. but no blower.
Possibly a relay, otherwise I am not sure good luck.
headlight gear is stripped.......headlight fixQuote:
Originally Posted by 99ls1taJohn
Yeah, I've been runnin' on the free 180 degree "fix" for over 2yrs now. :dance:
Do you hear the noise only while they opening and closeing or does it continue afterwards as well? Is the noise comming from inside or outside the car? When you say running lights are you talking about park lights?
the parking lights.....can hear it bought inside and outside but louder outside...it dont make any noise when i open them just when i close them...
thanks everyone for your help any more suggestions would be great!
Dude.... :haha: :true:Quote:
Originally Posted by 0rion
Yep its a vaccum line. There is a line that comes from the back of the intake over to the firewall on the passenger side and goes into the car right next to the AC lines.
There is a little t connector there that likes to melt/crack. I went thru 3 before I plugged the ends and coated the outside of a new one with some epoxy. going on 50,000+ miles without haveing to replace it again :)
:bat: You da man, I just got the car ready for spring fresh tune up and oil change and I replaced the tee with a tee from my old blazer an it works great.The old tee has four cracks in it and is now in a hundred pieces because I took care of it office space style.
Thank you
allow me to point you towards this post:Quote:
Originally Posted by 99ls1taJohn
Quote:
Originally Posted by 0rion
No problem!Quote:
Originally Posted by WS-6
Just "HOW" did you see anything at the rear of the passenger side valve cover? There does not appear to be any room from any direction. I check the t-shapedone over by the computer near the passenger firewall with a part from Oreillys & it did not help.
Could this have anything to do with the check engine light being on? I had a guy with a code reader check it & he said it was a vacuum problem with the emissions but that it should not have any effect on the rest of the car. HELP!!!
Quote:
Originally Posted by IronBird
What code(s) are you throwing? Is it only blowing out the defrost/floor vents like the original poster? Don't think a bad check valve will throw a code, just redirect the air inside the car.
I don't remember what the code reader showed, but he said it was emission related. He reset it & it came back on a week later & has stayed on. The car has run just fine with it on & mpg is normal. This a/c vent thing just popped up the last few days. No one has been messing around under the hood as some have said on other posting such a leaving something loose during mods. I'll try to check behind the passenger side valve cover this evening when things cool down.
And get the code read again and let us know what it is. Something else could be going on.
The check engine light came on originally several weeks ago & that was when I had it checked with the code reader gadget. After he reset it it came on approximately a week later, but nothing was out of the ordinary except for the light. The car ran exactly the same with the same mpg in city &/or highway driving.
The air conditioner problem just popped up the last couple of days. When you start the car & turn the control from off to max air or regular a/c, it just blows out the bottom/top vents, but not the ones facing the occupants. If you turn the control over to the 3rd position which indicates the floor & occupant facing vents, it comes out correctly. After having the control in this position, you can then turn it back to regular a/c, or max air & the air will then blow out the correct occupant facing vents.
I fiddled with it this evening & followed the vacuum line from the t-connection on the passenger firewall to the rear of the & it is still connected to another one, but I cannot do anything but just "feel" it. What to the shops do, drop the motor or something like that to get back there.
Any change this could be behind the climate control panel inside the car. I lost my manual for the 2002s a while back & have not ever had to remove anything in there yet. How does the panel give up access?
Thanks