I just leave the rubber on till it comes off on its own, I think it looks badass and shows the car gets down :lol:
Printable View
I just leave the rubber on till it comes off on its own, I think it looks badass and shows the car gets down :lol:
You always want to go for the sleeper look, man lol.
As much as a detail freak that I am, I would remove the rubber asap, and I never felt good about applying a wall of painters tape. Luckily for me my car has street tires on OE wheels, hardly gets dirty at the track. Since i'm a bitch and have a lack of tire spinning while standing still that factors in a little bit too maybe.. :lol:.
Good to know about the rubber remover. How'd you run at the track?Quote:
Originally Posted by kingls1
I probably have 2-3 sets worth of rubber in my rear fender wells. Just LOVE the smell of burning rubber. Also looks bada$$ seeing the smoke pouring out from the wheels. Probably lose 20lbs and another 2 tenths in the 1/4 if I ever took the time to scrap that sh!t outta there! LOL
http://i922.photobucket.com/albums/a...psehuqmvgq.jpgQuote:
Originally Posted by RONS98TA
It was a good day Ron
You could always get some of the 3M protective film that they use to protect the front end peices of a car.Quote:
Originally Posted by DarrenWS6
Nice sunny day today so i drove out to get the car in the air to
track down... and stop.... an annoying tinkly rattle sound from
underneath the car.
After prodding and poking everything it seems it was the fuel filter
canister moving in the bracket. There is no scope for adjusting the
bracket up any tighter so.... a good hefty zip tie got fitted to tug it all
towards the floor and snug everything up tight.
Worked a treat!
:) :nana:
Drove it to Williamsport today for a mall visit and a peak at the Ford dealer since I have a craving to go into debt again for a newer F-150. Fun time driving it and enjoyed flooring it on the on-ramps beating 70mph traffic to the exit lol!
Took her for a "spin"!☺️
http://i724.photobucket.com/albums/w...4A00607B_1.jpg
Hey guys,, could somebody point me to the place on this site that has instructions on how to post a picture with a reply ?! Thanks
Post pics to Photobucket....click on img in the info list to that pic...write your reply...click and hit paste! Should be good to go!
Hope that's helpful, I'm not really that good at this tech stuff!😳
^^ This. Open a free account at a photo sharing site like Photobucket or Image Shack, upload your pics and then copy and paste the [IMG] code into your post on here.
Thanks Jeff! I'm not great at typing out my thoughts!
Found this on FB...need one with the WS6 Ram Air front end on it!
http://i724.photobucket.com/albums/w...DE3CB0CD34.jpg
:haha: That is Awsome
Well after having the ac disconnected for the last 3 yrs I checked the ac on the car last night for leaks; held 30psi after a vacuum for 30 mins. :woot: Just need to add freon, oil & belt. :woot:
I was worried that the seals would go bad. Glad I sealed up the ac hoses and compressor when I did my engine pull.
Going over everything for my the session on Monday I discovered my water pump :suicide: So after replacing it and grinding the clearance needed for my 102mm throttle body to fit I also found some other issues like my hose from my catch can to the intake was rubbing on the belt. Fixed it and installed the ac belt back on as well as changed the break in oil. Picked up new set of TR6 plugs in case. Just leaves me topping off the coolant and finish installing my oil temp gauge, then load up the car on trailer.
Been driving it as I can weather permitting. Enjoying every last drive before salt hits the roads.
took it to the shop today for emissions and steering issues :mad:
^^ Details?