Printable View
This is an old version of autotap...it's hardware version 1. It has GM generic parameters only. It's shown in the top half of this picture. The black cable, red cd, floppy, and manual. It requires either a 9 pin port or you'll have to use a usb adapter if your laptop only has usb. $100 shipped
http://i268.photobucket.com/albums/j.../kart013-1.jpg
never heard of this before. what all can it do.
www.autotap.com
it's diagnostic software. you can log the car with this to diagnose issues. It also clears codes.
bump
what cars can it read? also does it have a live feed of the voltage changing on different sensors?
it's gm specific but doesn't read CAN protocol. I'm not sure when GM started using CAN. I've only used it on my 98 f-body and 97 truck and our old 99 GTP.
It's been a while since I've used it so my memory isn't real fresh on it. It does display voltages, I just don't remember what sensors it'll display voltages for. O2's I definitely remember because I used those to tune with and throttle position sensor and things like that. Later tonight I'll install the software on my laptop and hook it up and get some screen shots to put up.
so do you think it will work on my 02 ws6? im definitly interested if it will work on it.
I just went out and hooked it up to my 04 gto and it worked fine. I'll post a screen shot here in a little bit. What voltages were you specifically looking for and I'll see if they're supported. I'll have to play around with it a bit to remember how to use it. :D
here's a screen shot I took with a couple of the parameters I threw up there. There's also a gauge view and graphs you can set up. You can also export to excell to use spread sheets. This is what I used to log with back in the ls1edit days.
http://i268.photobucket.com/albums/j...um/autotap.jpg