Printable View
We're about to break ground on a new house, and I've been thinking very hard about putting a lift in the garage.
Any ideas on prices? Manufacturers? I've done a little bit of googling, but so far, everything has been 'call for pricing'. It's after hours most places, so I thought I'd give here a shot.
Here is a good place to start: Northern Tool Co.
http://www.northerntool.com/webapp/w...atchallpartial
I bought an off brand 2 post lift, but if I could do it over I would get an eagle. My lift works great but it leaks a little cause of the poor quality fittings. Now before everyone says why use it cause it works fine and when its up the locks hold the weight not the hydralics. Also make sure the concrete is thick enough and the proper psi rating. The last time I looked the eagle ones were around $3,000 mine was like $1,900. It is soooo much better than jackstands though.
I want to have a lift in my next place... make live SOOO much easier!
MOHAWK lifts are tough as nails
I was going to point that out. If you're breaking ground make sure they pour your garage extra thick.Quote:
Originally Posted by joejenkinsglass
even if you dont decide on a lift before your house is complete, just make sure its lift-ready for when you do get one. theyve mentioned concrete thickness, dont forget overhead clearance!
bought a challenger 9000 lb two post lift off ebay for $1,100 works great
love mine $1610. delivered,my concrete is 6 inches lift came with everything to install...love it
http://i93.photobucket.com/albums/l74/qwks15/007.jpg way better on the back then the floor:yup:
GO TO http://www.gregsmithequipment.com
9000 LBS., COMES WITH RAMPS,JACK TRAY, AND DRIP PANS.
We have a Direct Lift in my garage. Works great, goes up fast and has 2 locking mechanisms for safety. We had to have new concrete put in for the two lift posts so it would be the proper PSI rating.
I like Rotary stuff. I checked out a bunch of lifts before putting mine in and Rotary seemed to be the best. Besides concrete make sure the ceiling height is plenty high(if the hood is open when lifting a car). Where I work we have rotarys and they have Challengers at our training center. Even though the Rotary looks smaller they seem to flex less. They have all the specs including concrete reqs. on their site. Also, get the lines routed overhead less stuff in the way when using a trans jack etc.
http://i352.photobucket.com/albums/r...photos/003.jpg
^^ Very Nice! Beautiful cars too!
N.J. to VA. SS ?
YESQuote:
Originally Posted by Danger731
please believe when i build my first house..i will have at least 2 lifts in my garage...and on that day ..my wife/gf will probably start filing for divorce
I'm not too worried. My wife didn't want this in the backyard so we bought a piece of comm. property and build this. The 68 Camaro is her's. She's hot, smart and makes more bank than me.
will she marry me?Quote:
Originally Posted by NJ 666
That nova was on tv or something wasn't it??? I swear I've seen it before with those same graphics.Quote:
Originally Posted by NJ 666
Stole it...I mean bought it off the net like 7 years ago with that paint job. Was a former S/G car in NJ. I bought it fro upstate NY. A shame I haven't driven that car yet...it's almost done. Long story behind the car.Quote:
Originally Posted by Rhinohuey
Shady...maybe adopt another tax write off.
