Printable View
I have been trying to get out my u-joints all frikin day... stock ones around 150xxx... I beat, torched and pressed and finally they gave way... and the new ones were just as big as an ass to get back in...and I polished the piss outta the driveshaft... mirror finish...
BOB SAGGET!!!!!!!!!!!!!!!!!!!!!!!!
No such thing as a small job:lol:...i've even had nightmare oil changes
Hammer+Socket+finger=SOB!!
Hand+Hot Driveshaft=SOB!!!
Needle Bearings= SOB!
I have done em' that way for a long time! But until recently, I purchased a ball joint press. Took me 5 minutes and I was done!Quote:
Originally Posted by JoshieDoom
...I think that would be a hell of an investment
i had the same problem with mine, i had to torch it, untill that plastic crap that gm injects in there shot out like puss out of a pimple, then did the socket and hammer did the trick
yea now that you'll never have to do it againQuote:
Originally Posted by JoshieDoom
You polished your pole....
:lmao:Quote:
Originally Posted by Mr. Luos
:jerkit:
hes not the only one. lolQuote:
Originally Posted by Mr. Luos
Well I tend to do it on a daily basis anyway..mothers aluminum compound was used today tho.. I work on a bunch of friends vehicles.. plus my familys... plus I have a shop... so ... i think.. damn awesome investment