Does anyone know the best way to wire the electric cutout for a 99 ta. Where to route the wires and where to connect them.
Printable View
Does anyone know the best way to wire the electric cutout for a 99 ta. Where to route the wires and where to connect them.
good info to know. i just ordered my cutouts 2 weeks ago and have to install. thanks for the good link. Do you guys have 1 or 2 cuouts on your car? if I do to on the "Y" section of my pipe right after the O2 sensors will it sound better?:dunno:
that's pretty mucht the only place you can put it, unless you have an adjustable borla
i have an adjustable borla, but run it muffler bypass already. Im looking to make a some more noise if you know what i mean. the system im using is by DMH. its new and isnt on their site yet. it doesnt interfere with ground clearence AT ALL. thats why i was going to put it on the front part of the Y-pipe. how does your cutout sound with just one placed in that location? is it going to be much louder than my borla without plates?:hyper:
What if I have the loudmouth exhaust. Is there a good place to put the cutout because on the picture it looks like the cutout is where the loudmouth muffler is? Is there a certain place i should put it?
I have mine under the passenger rear seat and ran my wiring through that grommet which is right there. I pulled the passenger seat and ran the wiring under the carpet to the console and switch then ran it under the dash to the fuse box.