Two WS6 Questions. Rear End Clunk & Jacking Up Front End.
#1-I seem to have a lot of play/slack in the rear pumpkin. At slow speeds when you gently go on the throttle and off, like in traffic, the rear end clunks. It's kind of puzzling because I only have 10K on the car. Trans shifts as it should. Do these cars have a history of pinion gears needing adjustments ?
#2-I am going to install my UMI Torque arm this weekend and the directions say it is best to get the vehicle on 4 jack stands. No problem with the stands, I have 4 of them but how would I go about getting the front end on them ? Can you jack up the front with a floor jack ? If so, what's the jacking point ?
My idea had been to put the front on RaceRamps and raise the rear by floor jack and put two stands under rear axle. That's actually what I have done when installing LCA's,SFC's,Panhard Rod,Front & Rear Sway Bars. I've always had the two stands on rear axle and then back on jack to tighten completely.
Thanks. Happy Thanksgiving to ALL !:hi:
