Help!!!

I just took my c5 out on the road for the first time in a month and a half, i run it about once a week in my garage to keep things fresh. I took it out tonight to get gas, and after a few miles the car started running very rough. Stumbling, hardly any power, running rough. At a light, the car would start idling rougher and rougher. My SES light started flashing bring up all these codes. IDK whats going on. help meeee

pcm- p0300, p1153

BCM- b0605, b0503, b0508, b2592

ipc- ull60, 1088

and other codes- b2282, b2284, 2262, 1064, 2283, 2285, 2263

im in the process of resetting the computer by way of battery disconnect. Does anyone know what the problem might be? I just lost my trans am due to some girl running into me, the vette's all i got left.

Quote:

---

Originally Posted by Ramairgod84

I just took my c5 out on the road for the first time in a month and a half, i run it about once a week in my garage to keep things fresh. I took it out tonight to get gas, and after a few miles the car started running very rough. Stumbling, hardly any power, running rough. At a light, the car would start idling rougher and rougher. My SES light started flashing bring up all these codes. IDK whats going on. help meeee

pcm- p0300, p1153

BCM- b0605, b0503, b0508, b2592

ipc- ull60, 1088

and other codes- b2282, b2284, 2262, 1064, 2283, 2285, 2263

im in the process of resetting the computer by way of battery disconnect. Does anyone know what the problem might be? I just lost my trans am due to some girl running into me, the vette's all i got left.

---

P0300 Engine Misfire Detected
P1153 Heated Oxygen Sensor (HO2S) Insufficient Switching Bank 2 Sensor 1

B0605 BCM Internal Memory Function
B0503 RH DRL Relay Circuit
B0508 LH DRL Relay Circuit
B2592 Column Lock/Unlock Drive (B)

U1160 Loss of Communications with LDCM

B2282 Battery #1 Fault
B2284 Battery #2 Fault
B2262 Horizontal Position Sensor Fit
U1064 Loss of Communication with BCM
B2283 Battery #1 Fault
B2285 Battery #2 Fault
B2263 Horizontal Position Sensor Fit

:think:

Well bad gas or moisture could cause the first two, but with all the other codes thrown chances are somethings up with the computer. Possibility that a mouse or something got in there and chewed some wires.

Also was the battery low when you tried to start it? I know with the newer c6's if you try to start them with a low battery it can trip all sorts of codes and really mess things up. Had this happen all the time with the showroom vettes that just sat at my old work place.

I think I know what caused it. It's been raining like hell here for the past few days, and I took it out last night to get gas, and there were a few areas where water was running on the road, so I think the 02 sensors just got wet. I drove it to work this morning and it was fine. lol now i just worry about the battery going dead while im at work for 12 hours.