performabuilt
Member

Hello I was wondering how can I send you a tranny back? I wanna restore it and maybe upgrade to a lvl3 4l60e with 3800 stall. I lost the first box so where would you suggest would package it? Also do yall send a shipping sticker or do I need to send it to your address?

Does the $950 restore include the torque converter?

do you guys not do M6's?

Ok heres my problem....I have a 2000 camaro that had a 3.8L in it....pulled that and I am putting a LS1 in instead. My question is can I still use this tranny(4L60E i think) and just swap the bellhousing to a v8 bellhousing and put a different torque converter in it or will I have to get a whole new tranny??

Thanks in advance for the help!!

No other than on day normal driving then set overnight , start warm up and make sure fluid is at top of crosshatch

is there a break in period for your trannys? if so what method do you recommend?

ok, i have stock 2.73 gears, there wouldnt be a problem upgrading them after installing the tranny and torque converter if it was made for 2.73's would there?

hey, i recently ordered on of your 4L60E and the guy needed to know what my rear end gear ratio was, y is that? do new ones come with the transmission?

Just had my trans rebuilt, 3rd and 4th clutch seized up. Shifts fine at cruisn' speeds around town but at the track from a dead stop at wide open throttle it bounces off the rev lmiter between third and fourth gear, won't shift unless i get out of the throttle and back in. The trans shop says, "i need to get the shift points recalibrated, because of the shift kit they installed.........any truth to that? thanks for the help, chris

Yes the 2002 will work sicknick

check fliud levels and condition spikito