Results 1 to 1 of 1
-
11-30-2012, 02:11 AM #1
Injector Slope Setting is Too High
for my mods. I've taken my CAI apart, checked each of the connections and rubberized bands for tears and rips. I've re-installed it with an extreme amount of care and that has not resolved the issue. My slope is set about 8% higher than it should be based on mods. I have a catch can, descreened maf and breather filter.
I figure my setting should be 10% at most, which is where I was at after a dyno tune. I've had to increase it to eliminate lean codes.
Any suggestions on where to look and how to isolate it are welcome.
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Help: MAF jumping up and down at high rpm and effecting injector d
By NickatinaREX7 in forum Computer & TuningReplies: 0Last Post: 02-13-2017, 11:59 AM -
How's that slippery slope?
By SMWS6TA in forum Political / Debate ForumReplies: 17Last Post: 07-15-2015, 02:50 PM -
Example of the slippery slope of Gun Control Laws
By SMWS6TA in forum Political / Debate ForumReplies: 8Last Post: 10-25-2013, 08:45 AM -
What setting should I have it too?
By JwMonE99 in forum Suspension and HandlingReplies: 3Last Post: 09-04-2009, 01:06 PM -
The Slippery Slope of Same-Sex "Marriage"
By zleeper z in forum Political / Debate ForumReplies: 34Last Post: 06-08-2006, 05:49 AM
Bookmarks