Results 1 to 4 of 4
Thread: camshaft pos. sensor
-
04-10-2008, 08:53 AM #1
camshaft pos. sensor
Can anyone help me by telling me how hard it is to replace a camshaft position sensor? Mine came up on the diagnostic display and I have to replace it. Thanks '02 WS6
-
04-10-2008, 07:55 PM #2
you will need to pull the intake to get at it. it's located on the back of the block next to the oil pressure sending unit. not overly difficult to do.
Cold Air Intake, Muffler Delete, Vinci High Performance Dual Valve Springs, Hardened Pushrods, Yella Terra 1.85 Rockers, Some Hydropdipped Stuff, Strut Tower Brace, Some SS Badges, boost/vacuum gauge, fuel pressure gauge, some checkered stripes, drilled/slotted rotors, ZL1addons Stealth wickerbill, Ruxifey LED side markers
-
04-11-2008, 07:16 AM #3
the two times I have seen that code, the cam hardwarde was loose on the gear and the cam was walking...
-
04-27-2008, 10:37 PM #4
- Join Date
- Oct 2005
- Location
- calif.
- Posts
- 214
If you have done a recnt cam change--I would do the "cam position re-learn procedure" 1st--A must with new cam installs---Any tuner can do it for you--It may be all you need done---
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
P0342 camshaft pos sensor
By RONS98TA in forum Computer & TuningReplies: 0Last Post: 05-07-2013, 05:07 AM -
Question: 03 durango crankshaft sensor and camshaft
By JayTA98 in forum General HelpReplies: 4Last Post: 05-16-2011, 08:41 AM -
Camshaft Sensor Replacement
By regerror6 in forum Internal EngineReplies: 7Last Post: 04-28-2009, 02:49 PM -
Camshaft position sensor
By chris99SS in forum Internal EngineReplies: 2Last Post: 07-19-2007, 05:03 PM -
PO342 Camshaft Position Sensor low input code?
By yellowv in forum Computer & TuningReplies: 1Last Post: 04-12-2007, 09:19 PM
Bookmarks