Results 1 to 4 of 4
Thread: What is the best fit..
-
11-03-2009, 02:22 PM #1
What is the best fit..
i have an 02 T/a and looking to put 4.10 gears in it. I have seen alot of different bearing sizes and ring sizes for a ten bolt rear end. I have a 4l60e trans w/ B&M trans pak shift kit..
what places should i look for gears.
any thing extra that is needed in a 4.10 swap
also, how much better is your car now (any dyno numbers)
thanks,
-
11-03-2009, 03:01 PM #2
4.10 gears in an auto might be a bit much, but I'm sure you know what the results will be.
I bet Mark at www.KYSPEED.com can get you a good deal on any Moser parts as hes an authorized Moser dealer. If you insist on putting money into the 10 bolt, get the ring and pinion, and set up kit that includes all bearings and seals.
-
11-03-2009, 04:05 PM #3
-
11-03-2009, 04:08 PM #4
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Bookmarks