Results 1 to 3 of 3
Thread: Rear end
-
09-20-2006, 08:52 PM #1
- Join Date
- Sep 2006
- Location
- US
- Posts
- 2
green- 1998 Camaro Z28
Rear end
Hi, I have a 98 Z28 and the rear end needs all new bearings. Are you able to take the 3rd member out and rebuild it on a table for example or do you have to work on it in the air? I was also wondering what would be the best modification to do next. It has 124,000 miles on it. I put a SlP cat-back on. I was thinking about a slp flopac. I was wondering what would be a really good modification that would increase power and life of the vehicle and that is not too expensive? As for the rear end either 3.73 or 4.10 but then i would have to buy a programmer which are expensive. Other than recalibrating things for the axle ratio are the programmers really worth buying?
-
09-21-2006, 04:31 AM #2
get a 12 bolt. rebuilding the 10 bolt is worthless.
-
09-21-2006, 01:26 PM #3
Misfit is correct. I'm telling you from money waisted here. Get a 12 bolt or a Ford 9 inch and you will never have to spend money on it again. And just go on to the 4.10:1 because you will sooner or later. I have my old 7.5 in the back yard and plan on dumping it into lake arlington as soon as the water level gets higher from the draught. Or if you want it?????????????
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Rear LS1 98-02 Rear Disc Backing Plates/Calipers/Brackets
By peetsjunkie in forum Parts Wanted / TradeReplies: 2Last Post: 10-02-2007, 08:53 AM -
Rear alignment is off after Koni/!= rear isolator lowering, car pulls to right, specs
By anestech* in forum Suspension and HandlingReplies: 13Last Post: 07-08-2007, 09:42 AM -
Rear alignment issues after removing rear spring isolaters, adj trac bar fix it?
By anestech* in forum Suspension and HandlingReplies: 1Last Post: 06-19-2007, 07:06 PM -
Randy's Rear End Shop Get's Punked (Prank) - Woman looking for a bigger rear!
By powermelissa in forum Multimedia SectionReplies: 0Last Post: 05-25-2007, 10:37 AM -
how to remove the rear inside panels, where the rear spkrs are ?
By Eugenio_SS in forum ConvertibleReplies: 4Last Post: 05-19-2006, 04:39 PM
Bookmarks