I feel like an idiot...

[Mr. Luos]

Just got my Moser 9" in.

Looking to install this weekend.
Center section is held into housing with WHAT?? There are no threads for bolts to hold it in place.
Backing plates....same thing. How do these stay in place?? I have bolts, but the housing has no threads.


Axle bearings...those get pressed onto the wheel end of the axle right???

TIA

[Ed Blown Vert]

You should have bolts and nuts to hold on the center-section.

[Mr. Luos]

Just found where I need to buy the nuts myself.

[Mr. Luos]

One other thing...

No ABS...does the wheel speed sensor get left off then??

[Mr. Luos]

Okay...starting to get this.

The gear piece inbetween the wheels studs and the backing plates is....???
Needs to be put onto the new axles correct??

[Mr. Luos]

The gear piece inbetween the wheels studs and the backing plates is....???

ABS reluctor ring right??

Don't need it if I went without ABS?


God I feel like an idiot. What order does this stuff need to be pressed on??
Axle, backing plate, bearings?
The backing plate came off once the axle was pulled out stock (not pressed to it), apparently it works different on the 9"?
On the 9", the bearings hold the backing plate on, then the axle is put into place by the backing plate?

Jesus....

[Mr. Luos]

I just need to put the rear back into the car.

Anything that didn't go together I forced.
Got all questions answered...well enough.